User's Manual Part 1
Table Of Contents
- Copyright © 2004, Vivato, Inc.
- Who Should Read This Document?
- Printing This Document
- VIVATO, INC. END USER LIMITED WARRANTY AND LICENSE TERMS
- Safety Information
- Conventions Used in This Document
- Contact Information
- VIVATO, INC. END USER LIMITED WARRANTY AND LICENSE TERMS 3
- Safety Information 9
- Introduction 23
- Installation 29
- Initial Configuration Using the Built-In Web Pages 35
- Using the Main Configuration Web Pages 51
- Network Configuration Web Pages 55
- Security Configuration Web Pages 71
- Monitoring Clients and System Operations 79
- Services, Password, Config, and Firmware Web Pages 85
- Diagnostics Web Screen and Help 93
- Configuration Using The Command Line Interface 95
- Network Monitoring 145
- Verifying Wi-Fi Operation 149
- Dynamic Assignment of Client IP Addresses 153
- Updating AP/Bridge Firmware 159
- Introduction
- Powered Ethernet
- Omni-directional Antennas
- Ethernet and Serial Ports
- Reset To Factory Defaults
- Metal Enclosure
- IEEE 802.11 ISM-Band Channel Operation
- Multi-AP/Bridge Operation for Extended Coverage
- Basic Service Set Operation
- Web Page or Command Line Interface Configuration
- Network Configuration Examples
- Specifications
- Shipping Contents
- Installation
- Initial Configuration Using the Built-In Web Pages
- Using the Main Configuration Web Pages
- Network Configuration Web Pages
- Security Configuration Web Pages
Copyright © 2004, Vivato, Inc. Vivato Wi-Fi AP/Bridge User Guide 9
Safety Information
Safety Information
You must heed any and all safety precautions and warnings in this document or indicated on the Vivato
Wi-Fi AP/Bridge whenever you are operating or servicing this product. Failure to comply with all
precautions and warnings found in this document violates the design, manufacture, and intended use
requirements of the product. Vivato, Inc. assumes no liability for the operator’s failure to obey these
warnings and cautions.
The person installing the Vivato Wi-Fi AP/Bridge must be qualified by Vivato, Inc. or by a Vivato
authorized reseller.
This product must only be serviced by qualified Vivato personnel or its
certified agent.
Power Supply: A separate direct current (DC) power supply is shipped with the Vivato Wi-Fi
AP/Bridge. Do not attempt to use a substitute power supply unless it has been approved by Vivato for
use with this product.
Do not operate this product in an explosive atmosphere or in the presence of flammable gases or
fumes, or in the presence of unshielded blasting caps.
To protect against fire, replace any fuses in the product with those of the same voltage, current rating,
and type. Never short-circuit fuse holders or use modified fuses.
Keep away from energized circuits. Only qualified Vivato service personnel or its certified agent may
remove the outer covers of the product. Hazardous voltages may be present any time a cover is removed,
even if the product is not turned on.
Do not operate this product if damage is indicated. Refer servicing or repair to qualified Vivato
personnel or its certified agent.
Do not service or adjust this product by yourself. It is recommended that someone else is present who
can render first aid in the event that electrical shock or other injury occurs.
Do not substitute any parts or modify the product. Any unauthorized changes to the product could
result in compromising the safety features or the correct operation of the product. Refer any service or
repair to authorized Vivato personnel or its certified agent.
Operation With Antennas Not Included With The AP/Bridge
The combinations of antennas listed in Table 1—Tested Antenna Configurations on page 10 have
been tested with the Vivato Wi-Fi AP/Bridge and have shown to comply with FCC Part 15 rules when
used in the test configurations shown in Figure 1— Test Configurations for Antenna Qualification
on page 10.