Installation Instructions

ManualsBrandsVivi ManualsOffice ElectronicsVivi Wireless Presentation

Vivi Instructions

Installing the Box

Skip to end of metadataGo to start of metadata

To install the Box, you will need:

1. An active network port on your local network.

2. A Display which can be connected using a HDMI cable.

3. A power outlet.

These all need to be close to each other – at least for the initial setup.

Once the Box is plugged in, it will boot up. Make sure the other connections are in place

first.

Depending on the setup of your local network, additional network settings may be needed

before the Box can be fully activated.

Antenna

On Wi-Fi models only, connect the antenna to the back of the Box.

Ethernet

Connect the ethernet cable from the Box to your network.

Make sure both ends of the network cable are plugged in, and that the corresponding

network port is patched at the switch.

If you need to register the MAC address of the Box to gain access to the local network, it is

written on the side of the Box. The text will look like "D063B401C7F9" and corresponds to

a MAC address of d0:63:b4:01:c7:f9.

On Wi-Fi models, the network settings of the Box can be updated to use Wi-Fi later, but an

ethernet connection is needed the first time around so that the Box can be activated.

Summary of content (5 pages)

PAGE 1
Vivi Instructions Installing the Box Skip to end of metadataGo to start of metadata To install the Box, you will need: 1. An active network port on your local network. 2. A Display which can be connected using a HDMI cable. 3. A power outlet. These all need to be close to each other – at least for the initial setup. Once the Box is plugged in, it will boot up. Make sure the other connections are in place first.
PAGE 2
HDMI Connect the HDMI cable from your Display device to the Vivi Box. The HDMI cable can be connected to a VGA Display via a HDMI to VGA convertor or a HDMI to DVI convertor. However, this will only transmit video, and no audio. Human Interface Device (HID) compliant touch screens can also be used and can be connected via the USB connection. When initially setting up the device, it is best if a HDMI-capable Display device is used to simplify any troubleshooting that is required.
PAGE 3
Boot up and Box activation When you first plug in a new Box, it may take a few minutes to self-extract its operating system and get itself ready for use – this only happens the first time. At this point you should see a red light on the Box. After a few start up steps, the Vivi logo and either the Box name or a room name will appear on the Display. The Display may flicker for a few seconds while the device installs and activates.
PAGE 4
If you see this message on start-up, additional network configuration updates will be required. Add the required firewall exceptions and open the required internal network ports. Once they are in place, disconnect and reconnect the power so that the Box can reboot and run through the activation process again.
PAGE 5
FCC Warning This device complies with part 15 of the FCC rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any inte rference received, including interference that may cause undesired operation. Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment.