User's Manual
Table Of Contents
- Contents
- Introduction
- System Overview
- System Setup
- Configure System Settings
- System Settings Configuration Outline
- System Settings Complete List
- Security Sensor Numbers and Types
- Wireless Zones Configuration
- Wired Zones Configuration
- Key Fobs Configuration
- Keypads Configuration
- Entry and Exit Settings
- Installer Settings
- Key Fob Behavior Settings
- Central Station Settings
- Reporting and Troubles Settings
- Emergency Buttons Settings
- System Options Settings
- System Registration Settings
- Z-Wave Settings
- Networking Settings
- Cameras Settings
- System Testing Settings
- Cellular Settings
- Sensor Bypass Settings
- Bell Cutoff Settings
- Update Settings
- Regulatory Information
- Where To Find Regulatory Compliance Declarations
- FCC and IC Regulatory Compliance Declarations
- Wireless Product Notice
- Operating Temperature and Humidity Range Notice
- Important Power Supply Notice
- Internal Backup Battery Notice
- Regulatory Notes
- Applicable Warnings for Technicians
- Default Settings for SIA CP-01-2014 Compliance
- FCC and IC ID Numbers for System Devices
- Fire Protection and Safety Information
- Service and Warranty Information
- Specifications
System Setup: System Setup Outline and Summary
- 11 -
System Setup
System Setup Outline and Summary
Thefollowingoutlineprovidesahigh-levelsummaryofallthetasksthatcomprisethesetupofaVivintSmartHub
panelandsystem.
1. Unpack the box.
UnpacktheSmartHubpanelboxandidentifythecontents.Thepackageshouldcontainthecontrolpanel,
powersupply,quicksetupcard,(NOTE:Youcanunpacktheotherdevices,suchassensorsand
cameras,atthistimebutdonotinstallthemyet.)
2. Locate an unswitched outlet for the power supply.
Identifyanunswitchedwalloutletwhereyoucanpluginthepowersupplyforthecontrolpanel.
3. Plug the power supply into the wall outlet.
Plugthepowersupplyintothepreviouslyidentifiedunswitchedwalloutlet.
4. Connect the power supply to the control panel.
Connectthepowersupplycabletotheportonthebacksideofthepanel,andthentuckthecablesnugly
intotheslot.
5. Wait for the panel to start up.
Waitforthepaneltoloadthefirmwareandforthetouchscreeninterfacetoappear.Donotinstallorplace
theperipheraldevicesyet(sensors,cameras,etc.),astheinitialpartofthesystemsetupisdescribedon
thepanelitselfviaonscreeninstructions.Pleasewaitforthepaneltobootupfirst,andforthatinitialsetup
screentoappear.Thisprocessmaytakeafewminutes.
6. Follow the onscreen instructions to add and configure devices.
Oncethepanelisfinishedbooting,followtheonscreeninstructionsthatwillguideyouthroughaddingand
configuringdevices,andfinishingthepanelsetup.
(Formoredetails,seetheseparatedocumententitled"SkyHubPanelDIYOnscreenSetupInstructions")