User's Manual

Configure System Settings: Entry and Exit Settings
- 37 -
Quick Arming
DEFAULT: Enabled
QuickarmingallowsthecustomertoarmthesystemwithouthavingtoentertheirUserCode.(Quickarming
reportsasUser0ifopen/closereportsaresent.)
l Thedefaultsettingallowsquickarming.
l Toturnoffquickarming,selectdisabled.
Auto Stay
DEFAULT: Enabled
(NOTE: Default Setting Required f or SIA CP-01 Compl i ance)
WhenautostayisenabledandthesystemisarmedintheAwayMode,ifanexit/entrysensorisnotviolated
duringtheExitDelay,thesystemwillarmintheStayMode.
l Thedefaultsettingenablestheautostayfeature.
l Toturnofftheautostayfeature,selectdisabled.
NOTE:TheautostayfeaturedoesnotswitchthesystemtoStayModeifthesystemisarmedtoAwayMode
usingakeyfobremoteorremotelyarmedviatelephoneorcomputer.
Exit Delay Restart
DEFAULT: Enabled
(NOTE: Default Setting Required f or SIA CP-01 Compl i ance)
WhenExitDelayrestartisenabled,re-enteringthroughanexit/entrydoorduringtheExitDelaywillrestartthe
ExitDelay.TherestartoftheExitDelaywillonlyoccuronetime;furtherviolationsofanexit/entrysensorwillnot
extendtheExitDelay.
l ThedefaultsettingenablestheExitDelayrestartfeature.
l ToturnofftheExitDelayrestartfeature,selectdisabled.
Quick Exit
DEFAULT: Enabled
ThequickexitfeatureallowstheusertostarttheExitDelaywhilethesystemisarmed.Whenthisfeatureis
enabled,aQuickExitbuttonappearsontheSecurityScreen.PressingQuickExitwhilethesystemisarmed
allowstheusertoleavethroughanexit/entrydoor.AftertheExitDelayexpires,thesystemwillreturntobeing
armedinthemodeitwasinbefore(eitherStayorAwayMode).