User's Manual
Table Of Contents
- Contents
- Introduction
- System Overview
- System Setup
- Configure System Settings
- System Settings Configuration Outline
- System Settings Complete List
- Security Sensor Numbers and Types
- Wireless Zones Configuration
- Wired Zones Configuration
- Key Fobs Configuration
- Keypads Configuration
- Entry and Exit Settings
- Installer Settings
- Key Fob Behavior Settings
- Central Station Settings
- Reporting and Troubles Settings
- Emergency Buttons Settings
- System Options Settings
- System Registration Settings
- Z-Wave Settings
- Networking Settings
- Cameras Settings
- System Testing Settings
- Cellular Settings
- Sensor Bypass Settings
- Bell Cutoff Settings
- Update Settings
- Regulatory Information
- Where To Find Regulatory Compliance Declarations
- FCC and IC Regulatory Compliance Declarations
- Wireless Product Notice
- Operating Temperature and Humidity Range Notice
- Important Power Supply Notice
- Internal Backup Battery Notice
- Regulatory Notes
- Applicable Warnings for Technicians
- Default Settings for SIA CP-01-2014 Compliance
- FCC and IC ID Numbers for System Devices
- Fire Protection and Safety Information
- Service and Warranty Information
- Specifications
Configure System Settings: Installer Settings
- 39 -
Installer Settings
Thissectioncontainsdescriptions,defaultvalues,andnotesabouttheInstallersettings.
Toaccessthesesettingsfromthecontrolpanel,goto:
Menu > Settings > Installer Toolbox > Installer
FromtheInstallerscreen,youcanviewandconfigurethefollowingsettings.
Installer Code (4 digits)
DEFAULT: 2203
TheInstallerCodeisthecoderequiredtoentertheInstallerToolbox.
l ThedefaultfortheInstallerCodeis2203.
l TochangetheInstallerCode,enteranew4-digitcode.
l KeepinmindtheInstallerCodemustbeuniquefromalloftheotheruserPINcodes.
IMPORTANT: BE SURE TO WRITE DOWN THE NEW CODE!
Lock Installer Programming After 48 Hours
DEFAULT: Enabled
Thissettingisprovidedtopreventtakeovers.Thecontrolpanelcanbesettolimitaninstaller’saccesstosystem
settingsafteraperiodof48hours.The48hourlockouttimerstartswhentheinstallerregistersthesystem.
Whendisabled,thisallowsforunlimitedfullaccesstosystemconfiguration(nolockout).
Todenyaccesstosystemconfigurationafter48hours,setthisoptiontoenabled.
Afterthe48hourlockouttimerhaslockedoutthesystem,thetimercanberesetthroughtheVivintPlatform
AdminTool.
Panel Debug Mode
DEFAULT: Off
Thisoptionisdimmedorgrayedoutinacustomerinstallation,whichisexpectedandproperbehavior,asitis
usedforinternaltestingpurposesonly.
Reset To Factory Defaults Button
DEFAULT: Enabled
UsethissettingtoenableanddisabletheResettoFactoryDefaultsbuttonthatislocatedinsidethecontrolpanel.
Thisisthehardbuttonlabeled"RESET"onthecircuitboardinsidethecontrolpanel.