User's Manual
Table Of Contents
- Contents
- Introduction
- System Overview
- System Setup
- Configure System Settings
- System Settings Configuration Outline
- System Settings Complete List
- Security Sensor Numbers and Types
- Wireless Zones Configuration
- Wired Zones Configuration
- Key Fobs Configuration
- Keypads Configuration
- Entry and Exit Settings
- Installer Settings
- Key Fob Behavior Settings
- Central Station Settings
- Reporting and Troubles Settings
- Emergency Buttons Settings
- System Options Settings
- System Registration Settings
- Z-Wave Settings
- Networking Settings
- Cameras Settings
- System Testing Settings
- Cellular Settings
- Sensor Bypass Settings
- Bell Cutoff Settings
- Update Settings
- Regulatory Information
- Where To Find Regulatory Compliance Declarations
- FCC and IC Regulatory Compliance Declarations
- Wireless Product Notice
- Operating Temperature and Humidity Range Notice
- Important Power Supply Notice
- Internal Backup Battery Notice
- Regulatory Notes
- Applicable Warnings for Technicians
- Default Settings for SIA CP-01-2014 Compliance
- FCC and IC ID Numbers for System Devices
- Fire Protection and Safety Information
- Service and Warranty Information
- Specifications
Configure System Settings: System Options Settings
- 57 -
l Enabledonburglaryalarm
l Enabledonfirealarm
l Enabledonanyalarm
l Enabledonanysystemtrouble
l Enabledfollowssounderalarmandstatus
l Enabledfollowsexitandentrybeeps
Cross Sensor 1, Cross Sensor 2, and Configure Cross Sensors
DEFAULT: Disabled
Thecontrolpanelcanbeconfiguredsosensors1and2mustbothbeviolatedduringasettimetotriggeranalarm.
Thisiscalled"crosssensor"verification.Whenenabled,ifonlyonesensorisviolated,thealarmwillnottrigger,
butatroublereportwillbesentforthesensorthattriggered.
NOTE:COandfirezonecannotbeusedforcrosssensors.
l Thedefaultsettingdisablesthecrosssensorfeature.
l Tousethecrosssensorfeature,selectenabled.
NOTE:Formoreinformation,seetheCrosssensortimeoutsetting(below).
Cross Sensor Timeout (in seconds)
DEFAULT: 10 seconds
Thecrosssensortimeoutisthemaximumperiodoftimeallowedbetweenviolationofcrosssensorsthatwill
triggeranalarm.Ifbothsensorsareviolatedwithinthistimeperiod,analarmwillbetriggered.Ifbothsensorsare
notviolatedwithinthistimeperiod,analarmwillnotbetriggered.
NOTE:Crosssensorverificationmustbeenabledforthisfeaturetofunction.
l Thedefaultsettingsetsthecrosssensortimeoutat10seconds.
l Tochangethecrosssensortimeoutduration,select(11-120)seconds.
Cameras Require Admin Code
DEFAULT: Disabled
LimitsaccesstoonlyAdminusers.Ifthisoptionisenabled,userswillbepromptedtoenteravalidAdminPIN
codeinordertoviewthedevice.