User's Manual

Smart Hub Setup Guide
- 72 -
Sensor Bypass Settings
Thissectioncontainsdescriptions,defaultvalues,andnotesabouttheSensorBypasssettings.
Toaccessthesesettingsfromthecontrolpanel,goto:
Menu > Settings > Installer Toolbox > Sensor Bypass
FromtheSensorBypassscreen,youcanviewandconfigurethefollowingsettings.
Quick Bypass
DEFAULT: Disabled
Normally,sensorsthatareviolated(open)atthetimethesystemisarmedwillrequiretheusertoentertheirPIN
codetoforcebypassthem.Thecontrolpanelcanbeconfiguredsothatwhenthesystemisarmedwithopen
sensors,aPINcodeisnotrequiredtobypasstheopensensor(s)andcompletethearming.
l ThedefaultsettingrequirestheusertoentertheirPINcodetobypasssensors.
l ToallowbypassingsensorswithoutrequiringtheusertoentertheirPINcode,selectenabled.
Auto Unbypass for Manual Bypass
DEFAULT: Enabled
Violated(open)sensorscanbemanuallybypassedbytheuseratthepanelorforcebypassedatthetimeof
arming.
Forcebypassedsensorsautomaticallyhavetheirbypassesremovedwhenthesystemisdisarmed.
Manuallybypassedsensorscanhavetheirbypassautomaticallyremovedatdisarmingorhavetheirbypasses
remaininplace.
l Thedefaultsettingautomaticallyremovesbypassesfrommanuallybypassedsensorswhenthesystemis
disarmed.
l Tohavemanuallybypassedsensorsremainbypassedwhenthesystemisdisarmed,selectdisabled.