Silver Pneumatic Arm TV Wall Mount Instruction Manual SKU: MOUNT-VW04G Scan the QR code with your mobile device or follow the link for helpful videos and specifications related to this product. https://vivo-us.com/products/mount-vw04g GET IN TOUCH | Monday-Friday from 7:00am-7:00pm CST help@vivo-us.com www.vivo-us.
WARNING! If you do not understand these directions, or if you have any doubts about the safety of the installation, please call a qualified technician. Check carefully to make sure there are no missing or defective parts. Improper installation may cause damage or serious injury. Do not use this product for any purpose that is not explicitly specified in this manual. Do not exceed weight capacity. We cannot be liable for damage or injury caused by improper mounting, incorrect assembly or inappropriate use.
TOOLS NEEDED Drill Phillips Screwdriver Pencil ASSEMBLY STEPS STEP 1 Remove plastic covers from wall mount bracket on arm (A). STEP 2 OPTION A: Wood Wall Installation Use arm (A) with a bubble level to mark drilling locations on wall where stud is located, and drill 2.2” deep holes using 3/16” bit. Use of a stud finder is recommended. Mount arm to wall using screws (W-A). Do not use (W-B) anchors for wood stud installation.
STEP 2 (Continued) OPTION B: Concrete/Brick Wall Installation Use arm (A) with a bubble level to mark drilling locations on wall, and drill 2.4” deep holes using a 3/8” bit. Mount arm to wall using screws (W-A) and anchors (W-B). STEP 3 Reattach plastic covers.
STEP 4 For VESA 300x300 and 400x400 TV mounting hole patterns, attach extensions (C, D) to VESA plate (B) in X pattern using M6x10mm bolts (F). For VESA 400x200 TV mounting hole patterns, attach extensions (C, D) to VESA plate (B) in horizontal pattern using M6x10mm bolts (F). (NOTE: If your TV has a VESA mounting hole pattern of 100x100mm, 200x100mm or 200x200mm, skip to step 5.
STEP 5 (Continued) OPTION B: Curved/Recessed Back TV With TV face down on a flat surface, secure VESA plate to the TV using bolts (M-C, M-D, M-E), spacers (M-H, M-I) and washers (M-G). STEP 6 Loosen wingnuts on VESA plate to make sure there is 4mm of space between wing nuts and VESA plate. Hang TV on arm, and secure with wing nuts (E). Tighten with wrench (I).
STEP 7 To adjust gas spring lift strength, turn the screw on the top of the center joint using 6mm Allen wrench (H). Clockwise will reduce strength, and counter-clockwise will increase (screw turns most easily when arm is facing straight forward). NOTE: If the mount makes a popping noise when raising or lowering, tighten the socket set screw on top of the adjustment screw using a large flat-blade screwdriver. STEP 8 Manage cables with the built in cable management system.
Love your new VIVO setup and want to share? Tag us in your photo! @vivo_us LAST UPDATED: 05/13/2020 Open Monday - Friday 7:00am - 7:00pm CST, our dedicated support team can offer immediate assistance with rapid response times. If any parts are received damaged or defective, please contact us. We are happy to replace parts to ensure you have a fully functioning product. help@vivo-us.com AVG.