Tabletop TV Stand Instruction Manual SKU: STAND-TV01T Scan the QR code with your mobile device or follow the link for helpful videos and specifications related to this product. https://vivo-us.com/products/stand-tv01t GET IN TOUCH | Monday-Friday from 7:00am-7:00pm CST help@vivo-us.com www.vivo-us.
WARNING! If you do not understand these directions, or if you have any doubts about the safety of the installation, please call a qualified technician. Check carefully to make sure there are no missing or defective parts. Improper installation may cause damage or serious injury. Do not use this product for any purpose that is not explicitly specified in this manual. Do not exceed weight capacity. We cannot be liable for damage or injury caused by improper mounting, incorrect assembly or inappropriate use.
TOOLS NEEDED DO NOT EXCEED WEIGHT CAPACITY. Failure to do so may result in serious injury. 110lbs (49.9kg) Phillips Screwdriver ASSEMBLY STEPS STEP 1 Connect base plates (A1, B1) to junction plates (A2, B2) using M6x10 bolts (C) as shown in the diagram. Use the Allen wrench (E) to tighten bolts. Apply soft pads (T) to base plates.
STEP 2 Connect the lower TV brackets (A4, B4) to the middle and upper TV brackets (A5, A6, B5, B6) using M6 nuts (D2). Use the crescent wrench (F) to tighten. NOTE: The middle and/or upper TV brackets may be left unused for smaller TVs that do not require the additional height.
STEP 3 Attach TV brackets to junction plates using M6x10 bolts (C) and M6 cap nuts (D1). Secure using the Allen wrench and crescent wrench (E, F). Attach plastic covers (A3, B3) to junction plates by pressing tabs into holes. B4 A4 C E D1 A2 B3 E B2 STEP 4 Attach assembled brackets to back of TV using bolts (M-S) and washers (J-L) according to mounting holes in TV. If bolts are too long, spacers (G-I) may be required.
STEP 5 OPTION A: Wood Stud Wall Drill a 1.75” (45mm) deep hole using a 5/32” (3.8mm) drill bit. Attach security wire (X) to hole using the M6x45 bolt (U) with washer (V) and tighten with a Phillips screwdriver. V U X 45mm 3.8mm OPTION B: Concrete/Brick Wall Drill a 2” (50mm) deep hole using a 5/16” (8mm) drill bit, and press concrete anchor (W) into hole. Attach security wire (X) to hole using the M6x45 bolt (U) with washer (V) and tighten with a Phillips screwdriver.
STEP 5 (Continued) Ensure that security wire (X) has little or no slack between the wall and TV. This will greatly reduce the risk of tipping.
Love your new VIVO setup and want to share? Tag us in your photo! @vivo_us LAST UPDATED: 03/06/2020 Open Monday - Friday 7:00am - 7:00pm CST, our dedicated support team can offer immediate assistance with rapid response times. If any parts are received damaged or defective, please contact us. We are happy to replace parts to ensure you have a fully functioning product. help@vivo-us.com AVG.