User Manual

3
ASSEMBLY STEPS
TOOLS NEEDED
22lbs
(9.98kg)
DO NOT EXCEED WEIGHT CAPACITY.
Failure to do so may result in serious injury.
Phillips
Screwdriver
STEP 2
OPTION A: Clamp Installation
Slide cable management clip (D) and base cover (F) on to bottom of pole (E). Attach pads (H) to clamp
(B) as shown in the diagram. Thread pole (E) onto clamp (B). Tighten grub screws in bottom of clamp
(B) using 3mm allen key (J). Secure clamp (B) to desktop as shown in diagram.
OPTION B: Grommet Base Installation
Remove screw from top of bolt in clamp (B). Stick so pads (H) to bottom of grommet
base (G). Slide cable management clip (D) and base cover (F) on to bottom pole (E).
Thread pole (E) onto grommet base (G). Tighten grub screws in bottom of grommet
base (G) using 3mm allen key (J). Slide metal pad (I) over bolt and slide through
grommet hole in bottom of desktop. Thread into bottom of pole (E).
STEP 1
Install pole cap (C) to top of pole (E).
E C
10-8 8m
m
J
D
E
F
B
H
10-8 0m
m
D
F
I
J
B
G
H