User's Manual
Table Of Contents
- ViVOpay 3000 Installation Guide for VeriFone Ruby
- May 2004 Version 1.0
- VeriFone Ruby Installation Guide
- 1. Clean the terminal
- 2. Power up the ViVOpay unit in strip test mode
- 3. Initiate the magnetic strip test on your POS terminal
- a. Press the "Function" and "7" keys simultaneously to exit the credit card payment application. Enter the password 1
66831. - b. While in the card-reader test mode, the terminal will display the track data being transmitted from the magnetic card or Dynamic Strip being used on your terminal.
- c. Plug the power cables into the power ports on the Ruby device and the printer.
- d. Connect the printer to the Ruby. The coiled cable plugs into the printer's COM4 port on the back of the Ruby.
- e. Plug power supply cable into an AC outlet.
- f. Wait until the Ruby boots up. It will take a few minutes.
- g. When the Ruby prompts for a cashier number, enter 1 and press enter.
- h. For the password, enter 123 and press enter.
- i. The Ruby will display 'Ready for sale'. You can now process transactions.
- j. Key in a dollar amount (e.g., 100 for $1.00). Press the FUEL key (located in the top row of keys near the right). If you enter a value of $20.00 or greater, the device will prompt for an Air Miles card later in the transaction.
- k. Press enter to select the BRONZE fuel type.
- l. Enter a pump number when prompted to (any number) and press enter.
- m. Press the TOTAL key.
- n. Press the CREDIT key. You will then be prompted to swipe a credit /debit card.
- a. Press the "Function" and "7" keys simultaneously to exit the credit card payment application. Enter the password 1
- 4. Position the Dynamic Strip and mark the correct position
- 5. Remove the protective covering from adhesive tab and affix Strip firmly in place
- 6. Verify the installation and terminate the test
- 7. Install the cable support clips
- VeriFone Ruby Installation Guide
- May 2004 Version 1.0
3 VeriFone Ruby Installation Guide V 1.0
VeriFone Ruby Installation Guide 1
The ViVOpay 3000™ patent-pending Dynamic Strip™ technology enables
contactless payments without hardware or software changes to existing POS
devices at minimum cost.
This document assumes that installers are familiar with their host POS system.
Obtain the necessary components by removing the following ViVOtech products
from the shipping carton:
• ViVOpay power adapter
•Dynamic Strip
• Alcohol Wipe
• Cable support clip
• ViVOpay 3000
Obtain the following products from your work area:
• Your POS terminal, turned on
• Ruby, powered up
• Serial link cable
•Pencil
The Plug-and-Play application is installed as follows:
1. Clean the terminal
NOTE: It is highly recommended that you review the procedure
at least once prior to exposing the adhesive mounting tapes.
Use the alcohol wipe to clean the POS terminal
case. Wipe the top and side areas around the
magnetic strip where the cable clips will be attached.
CAUTION: Do not push the pad into the strip!