User's Manual
Table Of Contents
- ViVOpay 3000 Installation Guide for VeriFone Ruby
- May 2004 Version 1.0
- VeriFone Ruby Installation Guide
- 1. Clean the terminal
- 2. Power up the ViVOpay unit in strip test mode
- 3. Initiate the magnetic strip test on your POS terminal
- a. Press the "Function" and "7" keys simultaneously to exit the credit card payment application. Enter the password 1
66831. - b. While in the card-reader test mode, the terminal will display the track data being transmitted from the magnetic card or Dynamic Strip being used on your terminal.
- c. Plug the power cables into the power ports on the Ruby device and the printer.
- d. Connect the printer to the Ruby. The coiled cable plugs into the printer's COM4 port on the back of the Ruby.
- e. Plug power supply cable into an AC outlet.
- f. Wait until the Ruby boots up. It will take a few minutes.
- g. When the Ruby prompts for a cashier number, enter 1 and press enter.
- h. For the password, enter 123 and press enter.
- i. The Ruby will display 'Ready for sale'. You can now process transactions.
- j. Key in a dollar amount (e.g., 100 for $1.00). Press the FUEL key (located in the top row of keys near the right). If you enter a value of $20.00 or greater, the device will prompt for an Air Miles card later in the transaction.
- k. Press enter to select the BRONZE fuel type.
- l. Enter a pump number when prompted to (any number) and press enter.
- m. Press the TOTAL key.
- n. Press the CREDIT key. You will then be prompted to swipe a credit /debit card.
- a. Press the "Function" and "7" keys simultaneously to exit the credit card payment application. Enter the password 1
- 4. Position the Dynamic Strip and mark the correct position
- 5. Remove the protective covering from adhesive tab and affix Strip firmly in place
- 6. Verify the installation and terminate the test
- 7. Install the cable support clips
- VeriFone Ruby Installation Guide
- May 2004 Version 1.0
4 VeriFone Ruby Installation Guide V 1.0
It is important that these areas be clean of any oily or greasy residue that will
interfere with the adhesive mounting tapes. Allow the terminal to air dry.
2. Power up the ViVOpay unit in strip test mode
Continue to hold the button for five seconds until a continuous beeping is audible.
The ViVOtech unit is now in strip test mode. In the test mode, the ViVOpay unit's
LED will flash approximately every two seconds to indicate the strip test mode. The
ViVOpay unit will automatically transmit factory-installed test data to the POS
terminal strip to allow the installer to correctly position the strip on the magnetic
head.
3. Initiate the magnetic strip test on your POS terminal
It is necessary to set the POS terminal in the Card Reader Diagnostics (test) Mode
in order to precisely position the Strip.
a. Press the "Function" and "7" keys simultaneously to exit the credit card payment
application. Enter the password 1 <alpha> <alpha> 66831.
Connect the Dynamic Strip cable to the back of
the ViVOpay unit. Connect the AC adapter into
an AC power outlet.
Simultaneously press the button at the rear of
the reader with the pencil and insert the power
connector from the AC adapter into the socket
on the back of the ViVOpay unit.
WARNING: Do not disassemble the AC adapters. Only
qualified technicians may service the adapters. The AC
adapters are intended for indoor use only; do not expose to rain
or snow. Do not immerse the AC adapters or the terminal in
fluid.