User's Manual

ViVOpay 4800 User Guide 6
Installing the ViVOpay 4800
The following pictures shows the ViVOpay 4500m installed in a counter top stand. Note
that the stand causes the unit to sit at a slight angle to the counter top surface.
Cable Installation
1. Turn the ViVOpay 4500m unit over to get access to the cable routing channels, power
jack, and RJ45 10-pin connector.
Note: Do not use 8-pin connectors as they can damage the jack. Use only ViVOtech-approved
cables with 10-pin connectors.
2. Select the channel to be used for routing the cable. You can choose to use either of the
2 channels on the bottom of the stand or any of the 3 channels at the bottom of the
4500m unit underneath the stand. This decision should be based on the installation
requirements.
3. If you want to use any of the channels on the bottom of the 4500m unit, you need to
remove the stand by depressing the spring clip on the wide side of the stand and lifting
the stand off of the 4500m unit.