Installation Guide

English

NOTE:

If the external IR illuminator setting is enabled, all DO-related settings you

previously congured in the Event conguration will be erased.

Since only one pair of digital output lines are available, once the IR illuminator is enabled,

the other Digital output options will be disabled.

IR Conguration

To congure the IR-related settings in camera rmware:

1. Open a browser management session according to your QIG (Quick Installation Guide).

2. On the main page, enter Conguration > Advanced mode > Media > Image (General

settings) > click on a tab at the lower screen to open Day/Night settings.

3. Select the checkbox in front of "Turn on external IR illuminator in night mode." Click

Save to preserve your setting.

Once the conguration is done, the network camera will automatically turn on the

illuminator when its light sensor detects low-light conditions, e.g., when the night comes.