User Manual

User Manual rev. 1.0. Feb. 2016
130
Parameter description:
 MVR Mode
Enable/Disable the Global MVR.
The Unregistered Flooding control depends on the current configuration in
IGMP/MLD Snooping. It is suggested to enable Unregistered Flooding control
when the MVR group table is full.
 Delete
Check to delete the entry. The designated entry will be deleted during the next
save.
 MVR VID
Specify the Multicast VLAN ID.
Be Caution: MVR source ports are not recommended to be overlapped with
management VLAN ports.
 MVR Name
MVR Name is an optional attribute to indicate the name of the specific MVR VLAN.
Maximum length of the MVR VLAN Name string is 32. MVR VLAN Name can only
contain alphabets or numbers. When the optional MVR VLAN name is given, it
should contain at least one alphabet. MVR VLAN name can be edited for the
existing MVR VLAN entries or it can be added to the new entries.
 IGMP Address
Define the IPv4 address as source address used in IP header for IGMP control
frames.
The default IGMP address is not set (0.0.0.0).
When the IGMP address is not set, system uses IPv4 management address of the
IP interface associated with this VLAN.
When the IPv4 management address is not set, system uses the first available
IPv4 management address.
Otherwise, system uses a pre-defined value. By default, this value will be
192.0.2.1.
 Mode
Specify the MVR mode of operation. In Dynamic mode, MVR allows dynamic MVR
membership reports on source ports. In Compatible mode, MVR membership
reports are forbidden on source ports. The default is Dynamic mode.
 Tagging
Specify whether the traversed IGMP/MLD control frames will be sent as Untagged
or Tagged with MVR VID. The default is Tagged.
 Priority
Specify how the traversed IGMP/MLD control frames will be sent in prioritized
manner. The default Priority is 0.
 LLQI
Define the maximum time to wait for IGMP/MLD report memberships on a
receiver port before removing the port from multicast group membership. The
value is in units of tenths of a seconds. The range is from 0 to 31744. The default
LLQI is 5 tenths or one-half second.
 Interface Channel Setting
When the MVR VLAN is created, click the Edit symbol to expand the corresponding
multicast channel settings for the specific MVR VLAN. Summary about the