User Manual

User Manual rev. 1.0. Feb. 2016
186
 Queue Shaper Excess :
Controls whether the queue is allowed to use excess bandwidth.
 Queue Scheduler Weight :
Controls the weight for this queue. The default value is "17". This value is restricted to 1-100.
This parameter is only shown if "Scheduler Mode" is set to "Weighted".
 Queue Scheduler Percent :
Shows the weight in percent for this queue. This parameter is only shown if "Scheduler
Mode" is set to "Weighted"
 Port Shaper Enable :
Controls whether the port shaper is enabled for this switch port.
 Port Shaper Rate :
Controls the rate for the port shaper. The default value is ?. This value is restricted
to ?-1000000 when the "Unit" is "kbps", and it is restricted to 1-? when the "Unit" is "Mbps".
 . Port Shaper Unit :
Controls the unit of measure for the port shaper rate as "kbps" or "Mbps". The default value
is "kbps".
 . Buttons:
Apply – Click to save changes.
Reset- Click to undo any changes made locally and revert to previously saved
values.