User Manual

User Manual rev. 1.0. Feb. 2016

Parameter description:

 Mode :

Configure the operation mode per system. Possible modes are:

Enabled: Enable DHCP server per system.

Disabled: Disable DHCP server pre system.

 VLAN Range :

Indicate the VLAN range in which DHCP server is enabled or disabled. The first VLAN ID must be

smaller than or equal to the second VLAN ID. BUT, if the VLAN range contains only 1 VLAN ID, then

you can just input it into either one of the first and second VLAN ID or both.

On the other hand, if you want to disable existed VLAN range, then you can follow the steps.

1. press “ADD VLAN Range” to add a new VLAN range.

2. input the VLAN range that you want to disable.

3. choose Mode to be Disabled.

4. press Apply to apply the change.

Then, you will see the disabled VLAN range is removed from the DHCP Server mode configuration

page.

 Mode :

Indicate the the operation mode per VLAN. Possible modes are:

Enabled: Enable DHCP server per VLAN.

Disabled: Disable DHCP server pre VLAN.

 Buttons

Add VLAN Range - Click to add a new VLAN range.

Apply – Click to save changes.

Reset - Click to undo any changes made locally and revert to previously saved

values.