User Manual

User Manual rev. 1.0. Feb. 2016
46
2-5.1.6 Access Management
This section shows you to configure access management table of the Switch including
HTTP/HTTPS, SNMP, and TELNET/SSH. You can manage the Switch over an Ethernet LAN,
or over the Internet.
Web Interface
To configure an Access Management Configuration in the web interface:
1. Select “Enabled” in the Mode of Access Management Configuration.
2. Click “Add new entry”.
3. Specify the Start IP Address, End IP Address.
4. Checked Access Managemnet method (HTTP/HTTPS, SNMP, and TELNET/SSH) in the
entry.
5. Click Apply.
Figure 2-5.1.6: The Access Management Configuration
Parameter description:
 Mode :
Indicates the access management mode operation. Possible modes are:
Enabled: Enable access management mode operation.
Disabled: Disable access management mode operation.
 VLAN ID :
Indicates the VLAN ID for the access management entry.
 Delete :
Check to delete the entry. It will be deleted during the next save.
 Start IP address :
Indicates the start IP address for the access management entry.
 End IP address :
Indicates the end IP address for the access management entry.