User Manual

User Manual rev. 1.0. Feb. 2016
92
2-5.2.4.2 Static Table
The section describes to configure the Static IP Source Guard Table parameters of the switch.
You could use the Static IP Source Guard Table configure to manage the entries.
Web Interface
To configure a Static IP Source Guard Table Configuration in the web interface:
1. Click “Add new entry”.
2. Specify the Port, VLAN ID, IP Address, and MAC address in the entry.
3. Click Apply.
Figure 2-4.2.5.2: The Static IP Source Guard Table
Parameter description:
 Delete :
Check to delete the entry. It will be deleted during the next save.
 Port :
The logical port for the settings.
 VLAN ID :
The vlan id for the settings.
 IP Address :
Allowed Source IP address.
 MAC address :
Allowed Source MAC address.
 Adding new entry :
Click to add a new entry to the Static IP Source Guard table. Specify the Port, VLAN ID, IP
address, and IP Mask for the new entry. Click "Save".
 Buttons:
Apply – Click to save changes.