Installation Guide

2
Revision History:
* Rev. 1.0: Initial Release * Rev. 1.2: Revise Mechanism Error
* Rev. 1.1: Replace U-Bracket * Rev. 1.3: Revise Mechanism Content
Package Contents
• Please avoid eye exposure or apply appropriate protection, such as wearing a pair of Infrared
protection glasses, when working with the product. Always use camera live view to oberve IR
lighting effects.
WARNING:
• The luminaire should be positioned so that prolonged staring into the luminaire at a distance
closer than 2.5 m is not expected.
• The external exible cable or cord of this luminaire cannot be replaced; if the cord is damaged,
the luminaire shall be destroyed.
• The light source of this luminaire is not replaceable; when the light source reaches its end of life
the whole luminaire shall be replaced.
• Please make sure Reinforce/Double insulation shall be maintained between LV supply and control
circuits after installation.
• This ood light shall be used with a IEC/EN 61347-2-13 approved LED driver with SELV output
equal to rated voltage of the luminaire, and output power of LED drivers shall be at least equal to
rated power of the luminaire.
• Terminal block is not included. Installation may require advice from a qualied personnel.
• The wall-mount (CMA-B04), laser alignment kit (CMA-A01),
remote controller (CMA-E01), and other accessory are
separately purchased.
• The screws and anchors for securing the illuminator to wall are
user-supplied. Apply M6 anchors or screws.
NOTE:
The 1/4" screws and washers are used to secure the illuminator
to an external camera housing.
Dimming
LED
Status
LED
On/Off
T
W
Zoom
50%
20%
10%
100%
75%
50%
25%
X4
X2
X2