Warning Before Installation Power off the Network Camera as soon as smoke or unusual odors are detected. Do not place the Network Camera on unsteady surfaces. Do not insert sharp or tiny objects into the Network Camera. Keep the Network Camera away from water. If the Network Camera becomes wet, power off immediately. Do not touch the Network Camera during a lightning storm. Do not place the Network Camera in high humidity environments. 1.
2. Physical Description Outer View Camera bracket Reset button Lens Microphone LED RJ-45 release button 3.
English Installation Concern 1.6~1.8m The camera is designed to capture human activities in a near-hemispheric field of view, at a place such as a cashier or bank counter. Due to the optical characteristics of wide-angle lens, image quality decreases as distance from an object increases. It is therefore recommended to install the camera within 3 meters or closer to the objects of your interest. The focus center should also be aligned with objects of importance, say, human faces.
IMPORTANT: NOTE: Record the MAC address before installing the camera. It is recommended to use an Ethernet cable that comes without the strain relief boot. You can remove the boot if your cable comes with one. Strain relief boot Mounting the Network Camera - Desktop or Wall Mount 1. You can install the camera to a desktop or to a wall by driving screws through the holes shown below. 2. Flip the hang ring to the top. You may also secure a camera to wall using the hang rings. 3.
English 5. Network Deployment Power over Ethernet (PoE) When using a PoE-enabled switch This Network Camera is PoE-compliant, allowing transmission of power and data via a single Ethernet cable. Follow the below illustration to connect the camera to a PoE-enabled switch via an Ethernet cable. PoE Switch POWER COLLISION 1 2 3 4 LINK RECEIVE PARTITION 5 When using a non-PoE switch Use a PoE power injector (optional) to connect between the Network Camera and a non-PoE switch.
6. Assigning an IP Address 1. Install “Installation Wizard 2” from the Software Utility directory on the software CD. 2. The program will conduct an analysis of your network environment. After your network is analyzed, please click on the “Next” button to continue the program. 3. The program will search for VIVOTEK Video Receivers, Video Servers, and Network Cameras on the same LAN. 4. After a brief search, the main installer window will pop up.
