User Manual
Table Of Contents
- Overview
- Accessing the Network Camera
- Using VIVOTEK Recording Software
- Using 3GPP-compatible Mobile Devices
- Using RTSP Players
- Main Page
- Client Settings
- Configuration
- System > General settings
- System > Homepage layout
- System > Logs
- System > Parameters
- System > Maintenance
- Media > Image
- Media > Video
- Media > Video
- Media > Video
- Media > Audio
- Network > General settings
- Network > Streaming protocols
- Network > SNMP (Simple Network Management Protocol)
- Network > FTP
- Security > User accounts
- Security > HTTPS (Hypertext Transfer Protocol over SSL)
- Security > Access List
- PTZ > PTZ settings
- Event > Event settings
- Applications > Motion detection
- Applications > Tampering detection
- Applications > Audio detection
- Applications > Package management - a.k.a., VADP (VIVOTEK Application Development Platform)
- Recording > Recording settings
- Local storage > SD card management
- Local storage > Content management
- Appendix
VIVOTEK
User's Manual - 9
Cable hole
P/N : 621055300G
Drill hole ( camera )
) tekcarb nwod tliT ( eloh llirD
Drill hole(camera)
Lens
CAT5
2. Attach the alignment sticker to a preferred location. Drill a cabling hole and the pilot
holes for the mounting screws. Route cables through the routing hole.
5.5 ~ 6.4mm
3-1
3-2
3. When connecting the Ethernet cable, use the cable housing to make sure the
connections are waterproof.
3-1. Pass an Ethernet cable through the seal dome, rubber seal, and the cable gland
body.
3-2. Properly install and fasten the components of the cable gland.