User manual

VIVOTEK
214 - User's Manual
bit 0 => Indicate whether to support both
zoom and focus function.
bit 1 => Only support zoom function.
bit 2 => Only support focus function.
bit 3 => Currently, this is a reserved bit, and
the default value is 0.
* It's strongly non-recommended to use this.
* This is reserved for compatibility and will not
be used after the version number (httpversion)
is equal or greater than 0400a.
* We replace "capability_remotefocus" with "
capability_image_c0_remotefocus".
npreset 0, <positive
integer>
0/7 Number of preset locations
eptz 0, <positive
integer>
0/7 For "nvideoin" = 1, the definition is as following:
A 32-bits integer, each bit can be set separately
as follows:
Bit 0 => 1st stream supports ePTZ or not.
Bit 1 => 2nd stream supports ePTZ or not, and
so on.
For nvideoin >= 2, the definition is different:
First all 32 bits are divided into groups for
channel.
Ex:
nvideoin = 2, bit 0~15 are the 1st group for 1st
channel, bit 16~31 are the 2nd group for 2nd
channel.
nvideoin = 3, bit 0~9 are the 1st group for 1st
channel, bit 10~19 are the 2nd group for 2nd
channel, bit 20~31 are the 3rd group for 3rd
channel.
Then, the 1st bit of the group indicates 1st
stream of a channel support ePTZ or not. The
2nd bit of the group indicates 2nd stream of a
channel support ePTZ or not, and so on.
* For most products, the last stream of a