User Manual
Table Of Contents
- Overview
- Ready to Use
- Accessing the Network Camera
- Using VIVOTEK Recording Software
- Using 3GPP-compatible Mobile Devices
- Using RTSP Players
- Main Page
- Client Settings
- Configuration
- System > General settings
- System > Homepage layout
- System > Logs
- System > Parameters
- System > Maintenance
- Media > Image
- Media > Video
- Media > Audio
- Network > General settings
- Network > Streaming protocols
- Network > SNMP (Simple Network Management Protocol)
- Network > FTP
- Security > User accounts
- Security > HTTPS (Hypertext Transfer Protocol over SSL)
- Security > Access List
- PTZ > PTZ settings
- PTZ
- Mechanical PTZ Operation
- Event > Event settings
- Applications > Motion detection
- Applications > DI and DO
- Applications > Tampering detection
- Applications > Audio detection
- Applications > Package management - a.k.a., VADP (VIVOTEK Application Development Platform)
- Recording > Recording settings
- Local storage > SD card management
- Local storage > Content management
- Appendix
VIVOTEK
User's Manual - 9
6. Install a MicroSD card, and, if preferred, connect DI/DO wires to the terminal block. The
AC/DC pins can accept either 12V or 24V power input with no polarity.
The DO pin can provide a 5V output, and the max. load is 50mA.
Connect the ground wire to a grounded earth rod with a resistance smaller than 4Ω, thicker
than 20AWG, to a ground rod 1.5 meters into the ground.
The grounding wire is user-supplied.
64GB
10
I
1
12345678910
1 DC pw-
12V
2 DC pw+
3 RS485+
4 RS485-
5 DI- (common GND for all DIs)
6 DI2+
7 DI1+
8 DO2-
9 DO1-
10 DO+ (5V)
Pin 1 is on the left.