Quick Installation Guide
11
English
You should prepare a power adaptor of the sufcient capacity for supplying 24V input.
Below are the requirements:
Working temperature Total consumption Power adaptor
-20°C ~ 60°C (-4°F ~ -140°F): 60W 3A
-40°C ~ 60°C (-40°F ~ 140°F): 100W 5A
11.
Also pass the combo cable of the IR illuminator through a waterproof connector.
12.
Connect the day/night signal lines from the IR unit to the DI/DO connectors on the
camera's terminal block. The IP9172 is shown here.
DO+(5V)
DO1-
DI1+
DI0+
DI-
RS485-
RS485+
AC/DC + PW
AC/DC- PW
Tout
The day/night mode DI connection enables the synchronization of IR light and the
automated day/night switching mechanism on the camera.
10.
Connect the Ethernet cable to the camera's RJ45 socket.
Name Color Gauge Description
V+ Red (20AWG) Power input
12~24V DC±10%
24V AC±10% (50~60Hz), (14.5VDC current controlled)
V- Black (20AWG)
(I) LED+ Green (26AWG) LED ON/OFF control; pulsed LED control synchronized with camera sensor
exposure time.
(I) LED- Yellow (26AWG) Ground
(O) D/N+ Purple (26AWG) Light sensor status output
1. Open = Day
2. Short = Night (20 lux for IR ON); day/night switch will have a 30 sec. delay.
(O) D/N- Blue (26AWG) Ground
(O) COM+ Orange (26AWG) RS485 interface control
(O) COM- Brown (26AWG)
Cable Pinouts (IR Illuminator)
IMPORTANT: