User Manual
Table Of Contents
- Overview
- Ready to Use
- Accessing the Network Camera
- Using VIVOTEK Recording Software
- Using 3GPP-compatible Mobile Devices
- Using RTSP Players
- Main Page
- Client Settings
- Configuration
- System > General settings
- System > Homepage layout
- System > Logs
- System > Parameters
- System > Maintenance
- Media > Image
- Media > Video
- Media > Audio
- Network > General settings
- Network > Streaming protocols
- Network > SNMP (Simple Network Management Protocol)
- Network > FTP
- Security > User accounts
- Security > HTTPS (Hypertext Transfer Protocol over SSL)
- Security > Access List
- PTZ > PTZ settings
- PTZ
- Mechanical PTZ Operation
- Event > Event settings
- Applications > DI and DO
- Applications > Audio detection
- Applications > Package management - a.k.a., VADP (VIVOTEK Application Development Platform)
- Recording > Recording settings
- Local storage > SD card management
- Local storage > Content management
- Appendix
VIVOTEK
348 - User's Manual
function getstatus Function type
getstauts : Information of smartSD internal status return value as
below:
smartsd_lifetime_num:
Accumulated amount of data that has been written
smartsd_lifetime_den:
Card-guaranteed amount of data that can be written
smartsd_lifetime_rate:
The ratio of smartsd_lifetime_num to smartsd_lifetime_den.
It means the accumulated percentage amount of flash block has been
written. The range is from 0 to 100 (unit: %). The SD card is
recommended to be replaced if the percentage reaches above 90%.
smartsd_spare_block_rate:
Usage rate of spare blocks.
It means the usage percentage of total spare block. The range is from
0 to 100 (unit: %). The SD card is recommended to be replaced if the
percentage reaches above 90%.
smartsd_data_size_per_unit:
Size (in sectors) of data to be written when Life Information1 is
updated.
smartsd_num_of_sudden_power_failure:
Indicates how many times power disconnection occurred during
write/erase operations
smartsd_operation_mode:
Enables/disables power-off detection and write error notification
smartsd_attached:
Indicate the smartSD is attached or not.