MD8562/8562D 2MP . Vandal-proof . Mobile Surveillance P/N:625015501G Ver1.1 Copyright c 2011 VIVOTEK INC. All rights reserved.
English Warning Before Installation Power off the Network Camera as soon as smoke or unusual odors are detected. Refer to your user’s manual for the operating temperature. Contact your distributor in the event of occurrence. Do not place the Network Camera on unsteady surfaces. Do not touch the Network Camera during a lightning storm. Do not insert sharp or tiny objects into the Network Camera. Do not drop the Network Camera.
1 Package Contents MD8562 (PoE) MD8562D (With power cord) General I/O Terminal Block Ethernet 10/100 RJ45 Plug Microphone In (pink) Power Cord Socket (black) Alignment Sticker Software CD 510000210G Quick Installation Guide / Warranty Card Ground Wire / Screws Screwdriver Moisture Absorber / RJ45 Female/ Female Coupler EN - 2
English 2 Physical Description Inner View Reset button Status LED Lens Screw Holes MicroSD/SDHC Card Slot Outer View IMPORTANT! Record the MAC address before installing the camera.
3 Hardware Installation First, use the supplied screwdriver to detach the dome cover from the camera base. Insert your MicroSD/SDHC Card if necessary. Tamper-proof Screw Dome Cover Plastic Cover Camera Base Then, follow the steps below to install the camera to either a ceiling or wall: 1. Attach the supplied alignment sticker to the ceiling/wall. 2. Using the 3 screw circles on the sticker, drill 3 pilot holes into the ceiling/wall. Then hammer the plastic anchors into the holes if necessary. 3.
English Wall Mount 1 2 IMPORTANT! Please secure the screws tightly to avoid moisture. B A 3 4 Installing the Ground Wire As shown in the figure below, secure one side of the supplied ground wire to the screw hole, route the wire, and attach the other end to a junction box or a grounded conduit.
4 Network Deployment General Connection (without PoE) (MD8562D) 1. If you have external DI devices, make the connection from general I/O terminal block. 2. Use the supplied RJ45 female/female coupler to connect the Network Camera to a switch. Use a Category 5 Cross Cable when Network Camera is directly connected to PC. 3. Connect the power cable from the Network Camera to a power outlet.
English Power over Ethernet (PoE) (MD8562) When using a PoE-enabled switch This Network Camera is PoE-compliant, allowing transmission of power and data via a single Ethernet cable. Follow the below illustration to connect the camera to a PoE-enabled switch via Ethernet cable. POWER COLLISION 1 2 3 4 5 LINK RECEIVE PARTITION PoE Switch NOTE: 1. This equipment is only to be connected to PoE networks without routing to outside plants. 2. For PoE input connection, use only UL listed I.T.E.
5 Assigning an IP Address 1. Install “Installation Wizard 2” from the Software Utility directory on the software CD. 2. The program will conduct an analysis of your network environment. After your network is analyzed, please click on the “Next” button to continue the program. Installation Wizard 2 3. The program will search for VIVOTEK Video Receivers, Video Servers, and Network Cameras on the same LAN. 4. After a brief search, the main installer window will pop up.
English 6 Ready to Use 1. A browser session with the Network Camera should prompt as shown below. 2. You should be able to see live video from your camera. You may also install the 32-channel recording software from the software CD in a deployment consisting of multiple cameras. For its installation details, please refer to its related documents. For further setup, please refer to the user's manual on the software CD.
Fine-tune the Camera Focus The focus of this network camera is set from 1.0 meter to infinity by factory default. If you want to focus on objects closer than 1.0m or the lens has lost focus, please fine tune it in the following way. 1. Loosen the lens lock screw under the lens module. 2. Manually rotate the lens to fine-tune the focus until the live image is clear. 3. Tighten the lens lock screw. Loosen the lens lock screw.
MD8562/8562D 2MP . Vandal-proof . Mobile Surveillance P/N:625015501G Ver1.1 Copyright c 2011 VIVOTEK INC. All rights reserved.
