User Manual
Table Of Contents
- Chapter One Hardware Installation and Initial Configuration
- Section One
- Management over a
- Local Console
- Chapter Two
- Introduction to the Local Console Interface
- Chapter Three
- Configuation Using the Local Console
- The Main Control Portal
- 3-3-1. Basic Search
- 3-3-2. Alarm Search
- 3-3-3. POS Search
- 3-3-5. Smart VCA event search
- 3-3-6. Storyboard
- 3-5-1. Settings - Overview
- 3-5-2. Settings–Camera–Management
- 3-5-3. Settings–Camera–Recording
- 3-5-4. Settings–Camera–Media
- 3-5-5. Settings - Camera - Image
- 3-5-6. Settings–Camera–Motion Detection
- 3-5-7. Settings - Camera - PTZ settings
- 3-5-8. Settings - Camera - Port forwarding
- 3-5-9. Settings - Camera - Update firmware
- 3-5-10. Settings–Alarm–Alarm
- 3-5-11. Settings - Alarm - Email
- 3-5-12. Settings–System–Information
- 3-5-13. Settings–System–Maintenance
- 3-5-14. Settings - System - Display
- 3-5-15. Settings - System - PoE management
- 3-5-16. Settings - System - UPS
- 3-5-17. Settings - System - Log
- 3-5-18. Settings - System - VIVOCloud service
- 3-5-19. Settings – System - Customer support
- 3-5-20. Settings–User
- 3-5-21. Settings–User-Login / Logout
- 3-5-22. Settings–Storage
- 3-5-23. Settings - Storage - Scheduled backup
- 3-5-24. Settings - Network
- Settings - Network - IP
- Settings - DDNS
- Settings–Service
- Section Two
- Management over a Web Console
- Chapter Four Login and Getting Started
- Chapter Five System Settings
- Safety and Compatibility
VIVOTEK - Built with Reliability
112 - User's Manual
To congure PTZ preset positions:
1. Select a PTZ camera by a single click.
2. Use the PTZ panel to move to a eld of view where you want to designate as a
preset position.
3. Click the add button, and enter a name for the position. Press Enter to proceed.
Repeat the conguration to create more positions.
4. Click the Apply button for the conguration to take eect.
Note that the PTZ panel can vary with dierent PTZ cameras.
3-5-7. Settings - Camera - PTZ settings
1
2
3
4