User Manual
Table Of Contents
- Chapter One Hardware Installation and Initial Configuration
- Section One
- Management over a
- Local Console
- Chapter Two
- Introduction to the Local Console Interface
- Chapter Three
- Configuation Using the Local Console
- The Main Control Portal
- 3-3-1. Basic Search
- 3-3-2. Alarm Search
- 3-3-3. POS Search
- 3-3-5. Smart VCA event search
- 3-3-6. Storyboard
- 3-5-1. Settings - Overview
- 3-5-2. Settings–Camera–Management
- 3-5-3. Settings–Camera–Recording
- 3-5-4. Settings–Camera–Media
- 3-5-5. Settings - Camera - Image
- 3-5-6. Settings–Camera–Motion Detection
- 3-5-7. Settings - Camera - PTZ settings
- 3-5-8. Settings - Camera - Port forwarding
- 3-5-9. Settings - Camera - Update firmware
- 3-5-10. Settings–Alarm–Alarm
- 3-5-11. Settings - Alarm - Email
- 3-5-12. Settings–System–Information
- 3-5-13. Settings–System–Maintenance
- 3-5-14. Settings - System - Display
- 3-5-15. Settings - System - PoE management
- 3-5-16. Settings - System - UPS
- 3-5-17. Settings - System - Log
- 3-5-18. Settings - System - VIVOCloud service
- 3-5-19. Settings – System - Customer support
- 3-5-20. Settings–User
- 3-5-21. Settings–User-Login / Logout
- 3-5-22. Settings–Storage
- 3-5-23. Settings - Storage - Scheduled backup
- 3-5-24. Settings - Network
- Settings - Network - IP
- Settings - DDNS
- Settings–Service
- Section Two
- Management over a Web Console
- Chapter Four Login and Getting Started
- Chapter Five System Settings
- Safety and Compatibility
VIVOTEK - Built with Reliability
User's Manual - 23
Terminal Block Connections
The terminal block pinouts is shown as follows:
The relay pins default status is set to Normally Open. Connect your relay or external devices’
signal wires to the system, the system will automatically detect the current signal status. You
can then trigger the external devices using the DI/DO panel on the live view.
You can also congure the system alarm setting for the system to automatically trigger a relay
pin on the occurrence of system events. See Alarm settings on page 117.
ssss
Normally Open
pin
Common pin
Normally Closed
pin
Coil
1 OUT
2 COM
3 OUT
4 COM
5 IN
6 IN
7 IN
8 IN
9 GND
10 GND
The GND are common ground for the DIs.
2-6. Limitations:
• When you are exporting video to the disk drives in an external storage, you cannot
select the other disk drives to create a new volume.
• If the disk drives or volumes in the external storage is smaller than 1TB, you
cannot congure them as volumes for the NVR.
• The connection interface to external storage must comply with the USB 3.0
specications.