User Manual
Table Of Contents
- Chapter One Hardware Installation and Initial Configuration
- Section One
- Management over a
- Local Console
- Chapter Two
- Introduction to the Local Console Interface
- Chapter Three
- Configuation Using the Local Console
- The Main Control Portal
- 3-3-1. Basic Search
- 3-3-2. Alarm Search
- 3-3-3. POS Search
- 3-3-5. Smart VCA event search
- 3-3-6. Storyboard
- 3-5-1. Settings - Overview
- 3-5-2. Settings–Camera–Management
- 3-5-3. Settings–Camera–Recording
- 3-5-4. Settings–Camera–Media
- 3-5-5. Settings - Camera - Image
- 3-5-6. Settings–Camera–Motion Detection
- 3-5-7. Settings - Camera - PTZ settings
- 3-5-8. Settings - Camera - Port forwarding
- 3-5-9. Settings - Camera - Update firmware
- 3-5-10. Settings–Alarm–Alarm
- 3-5-11. Settings - Alarm - Email
- 3-5-12. Settings–System–Information
- 3-5-13. Settings–System–Maintenance
- 3-5-14. Settings - System - Display
- 3-5-15. Settings - System - PoE management
- 3-5-16. Settings - System - UPS
- 3-5-17. Settings - System - Log
- 3-5-18. Settings - System - VIVOCloud service
- 3-5-19. Settings – System - Customer support
- 3-5-20. Settings–User
- 3-5-21. Settings–User-Login / Logout
- 3-5-22. Settings–Storage
- 3-5-23. Settings - Storage - Scheduled backup
- 3-5-24. Settings - Network
- Settings - Network - IP
- Settings - DDNS
- Settings–Service
- Section Two
- Management over a Web Console
- Chapter Four Login and Getting Started
- Chapter Five System Settings
- Safety and Compatibility
VIVOTEK - Built with Reliability
User's Manual - 75
Intrusion Detection
VIVOTEK Intrusion Detection can be used to detect people entering or leaving a virtual
area in the camera eld of view.
Alerted zone
The applicable scenarios of this feature can be:
* Detects when a person enters a bank vault or school after the oce hours.
* Detects when a person leaves an emergency exit or re escape, or any place that is
normally forbidden from access.
Line Crossing Detection
The Line Crossing detection detects one or multiple persons crossing a virtual trip-wire. The
trac direction can be assigned on screen for persons passing the line in one specic direction
or in both directions.
Out
In
Detection line
The applicable scenarios of this feature can be:
* Detects someone who enters a drive way, entrance, or exit through the virtual line.
* Detects and triggers an alarm in a predetermined direction.
* The detection line can be used as a fence boundary to know if someone has crossed the
articulated line around a perimeter.
Below are the short introductions to these analytics functions: