Operation Manual

VIVOTEK
8 - User's Manual
Installation
Hardware Installation
1
2
3
5
6
7
8
9
10
Silica gel
Silica gel
4
Mounting the Network Camera
1� Attach the alignment sticker to the wall�
2� Drill four pilot holes into the wall�
3� Attach the black cover to the Network Camera using the supplied four black screws�
4� Stick the supplied two pieces of moisture absorber symmetrically to the inner side of the
dome cover. Then place the metal ring into the dome cover to x the moisture absorber.
5� Fix the dome cover to the Network Camera and secure it by rotating it clockwise�
6� Loosen the three screws on the front opening of the wall mount bracket�
7� Place the O-ring on the front opening of the wall mount bracket�
8� Feed the cables through the front opening of the wall mount bracket and pull them from wall
outlet�
9� Attach the Network Camera to the wall mount bracket by tightening the three screws you
previously removed�
10� Fasten the wall mount bracket to the pre-drilled holes on the wall�
IMPORTANT!
The supplied L-type hex wrenches
are exclusively designed to match the
camera''s screws� Keep them for future
use� Do not discard the wrenches�