User Manual

VIVOTEK

66 - User's Manual

Preset positions

If you select DynaDome/SmartDOME, Lilin PIH-7x00, or Pelco D, Pelco P protocol, Samsung scc643

protocol protocol as the PTZ driver and click the Save button, the Preset Position button will be enabled�

Click Preset Position to open the settings page� You can also select preset positions for the camera to

patrol. A total of 20 preset positions can be congured.

Please follow the steps below to preset a position:

1� Select Channel in the drop-down list�

2� Adjust the shooting area to the desired position by using the buttons on the right�

The default Home

position is set as the center position�

3� Enter a name for the preset position, which allows up to forty characters� Click Add to enable the

settings� The preset positions will be displayed under User preset locations�

4� To add additional preset positions, please repeat steps 1~2�

5� Select the preset positions and click on Save to enable the settings�

6� The positions saved will show up in Go to drop down list on the Home page� See next page

7� To remove a preset position from the list, select it and click Delete�

Functions are the same

as the Control Panel on

the home page