User Manual
Table Of Contents
- Revision History
- Overview
- Accessing the Video Server
- Main Page
- Client settings
- Configuration
- System
- Security
- HTTPS (Hypertext Transfer Protocol over SSL) 
- SNMP (Simple Network Management Protocol) 
- Network
- Express link
- DDNS
- Access list 
- Digital I/O
- Audio and video
- Motion detection
- Camera tampering detection
- Camera control
- Homepage layout 
- Application 
- Recording > Recording settings 
- Local storage > SD card management
- Local storage > Content management
- System log 
- View parameters 
- Maintenance
- Appendix
VIVOTEK
40 - User's Manual
Please follow the steps below to link to an IPv6 address:
1. Open your web browser.
2. Enter the link-global or link-local IPv6 address in the address bar of your web browser.
3. The format should be:
4. Press Enter on the keyboard or click Refresh button to refresh the webpage.
For example:
► If you have a Secondary HTTP port (the default value is 8080), you can also link to the webpage in
the following address format: ( Please refer to HTTP on page 46 for detailed information.)
► If you choose PPPoE as the Network Type, the [PPP0 address] will be displayed in the IPv6
information column as shown below.
Manually setup the IP address: Select this option to manually set up IPv6 settings if your network
environment does not have DHCPv6 server and router advertisements-enabled routers.
If you check this item, the following blanks will be displayed for you to enter the corresponding
information:
http://[2001:0c08:2500:0002:0202:d1ff:fe04:65f4]/
IPv6 address
http://[2001:0c08:2500:0002:0202:d1ff:fe04:65f4]/:8080
IPv6 address
Secondary HTTP port
NOTE: