Owner`s manual

12
Display (LCD)
Multi-character displays: The 7-segment display
(upper) shows the VFO A frequency. The 13-
segment display (lower) shows VFO B or text.
Bar graph, receive mode: The bar graph normally
acts as an S-meter. If C W T is turned on, the right
half of the S-meter becomes a tuning aid (pg. 34).
Bar graph, transmit mode: The bar graph
normally shows SWR and RF power output. The
RF scale will be either 5 and 10 (low power) or 50
and 100 (high power). In voice and data modes,
transmit scales can be changed to compression
(CMP ) and ALC using M E T E R .
VFO Icons: The TX icon indicates which VFO is
selected for transmit. In TX TEST mode, or when
TX is inhibited externally, TX flashes (see T E S T ).
Shows that VFO A or B is locked (see
L O C K
).
TX
A
VFO A is the transmit VFO
TX
B
VFO B is the transmit VFO; see
Filter Graphic: This shows the approx. bandwidth
and position of the receiver’s I.F. passband. See
Filter Passband Controls, pg. 23.
Filter Icons:
NTC H Notch filtering on (N T C H , pg. 25)
Manual notch (MA N , pg. 25)
I / II Shows selected preset (I/ I I , pg. 14)
XFIL Crystal filter selection (FL1 -FL5 )
Mode Icons:
Basic modes (LSB / U SB , C W , D A T A , A M, or
FM) are selected by tapping either end (Up/Down)
of M O D E . Alternate modes (C W R EV, D A T A
REV, AM- S, FM +/-) are selected by holding
AL T . LSB and USB are alternates of each other.
+ icon on in SSB modes indicates ESSB (pg. 36).
T indicates FM/tone, CW/DATA text decode, or
AM-Sync auto-tracking.
Other Icons:
CWT CW/data tuning aid on (C W T , pg. 34)
DVR in use (A F R E C / AF P L A Y , pg. 16)
VO X VOX enabled (V O X , pg. 13)
QSK Full break-in CW enabled (QSK , pg. 30)
NB Noise blanker on (N B , pg. 15)
NR Noise reduction on (N R , pg. 15)
ANT Antenna 1 or 2 (A N T , pg. 13)
RX RX antenna in use (R X A N T , pg. 13)
ATT Attenuator on (AT T , pg. 15)
PR E Preamp on (PRE , pg. 15)
ATU ATU enabled (AT U , pg. 13)
RIT RIT on (R IT , pg. 16)
XIT XIT on (X IT , pg. 16)
SU B Sub receiver on (S UB , pg. 37)
SPL T Split mode in effect (SPL IT, pg. 36)
SPLIT