Owner`s manual

Fill in the table below (include sub receiver info, if applicable). Use pencil, since you may change the

configuration later. BAN D WID TH can be obtained from the model number of each filter. 5-pole filters have a

FRE Q OFFS ET marked on the side of one of the crystals, e.g. “-0.85”. The offset for all 8-pole filters is 0.00.

If you’ll be changing RF board filters: Turn the K3 upside down, placing a soft cloth beneath it.

Remove the seven black pan head screws retaining the front bottom cover, then lift the cover off.

Remove the screws holding any existing filters that you’ll need to move to obtain the order listed above (on

both the RF board and sub receiver).

RF BOARD (MAIN RX & TX)

SUB RECEIVER (RX ONLY)

POSITION

BANDWIDTH

FREQ OFFSET

POSITION

BANDWIDTH

FREQ OFFSET

FL1

FL2

FL3

FL4

FL5