User's Manual
Table Of Contents
- USER MANUAL Model: SB2021n-H6
- IMPORTANT SAFETY INSTRUCTIONS
- TABLE OF CONTENTS
- PACKAGE CONTENTS
- CONTROLS & CONNECTIONS
- FIRST-TIME SETUP
- USING THE REMOTE
- LED INDICATOR
- PROGRAMMING THE SOUND BAR
- USING BUTTON COMBINATIONS
- BLUETOOTH PAIRING
- USING BLUETOOTH MODE
- ADVANCED SETUP
- Reconnecting the Subwoofer
- HELP & TROUBLESHOOTING
- LIMITED WARRANTY
- United States and Canada
- How Long This Warranty Lasts
- What This Warranty Covers
- Zero Bright Pixel Defect Guarantee (Displays Only)
- How to Get Service
- Your Obligations Before Service
- VIZIO’s Responsibilities
- Types of Service
- What This Warranty Does Not Cover
- What to Do If You Are Not Satisfied With Service
- Binding Arbitration Agreement; Class Action Waiver (U.S. Residents Only)
- Exceptions to Binding Arbitration Agreement and Class Action Waiver
- Exclusions and Limitations
- How the Law Applies
- General
- Changes to Warranty
- Specifications
- LEGAL & COMPLIANCE
English - 29
FCC Class B Radio Interference Statement
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio
frequency energy, and if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment o and on, the user is encouraged to try to correct the interference by one or more of the
following measures:
1. Reorient or relocate the receiving antenna.
2. Increase the separation between the equipment and receiver.
3. Connect the equipment into an outlet on a circuit dierent from that to which the receiver is connected.
4. Consult the dealer or an experienced radio/TV technician for help.
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference,
and (2) this device must accept any interference received, including interference that may cause undesired operation.
Notice:
1. Any Changes or modications not expressly approved by the party responsible for compliance could void the user's authority to operate the
equipment.
2. Shielded interface cables and AC power cord, if any, must be used in order to comply with the emission limits.
3. The manufacturer is not responsible for any radio or TV interference caused by unauthorized modication to this equipment. It is the responsibilities
of the user to correct such interference.
FCC RF Radiation Exposure Statement
1. This transmitter must not be collocated or operating in conjunction with any other antenna or transmitter.
2. This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. This equipment should be installed and operated
with minimum distance 20cm between the radiator & your body.
FCC RF Warning
This equipment must be installed and operated in accordance with provided instructions and the antenna(s) used for this transmitter must be installed
to provide a separation distance of at least 20cm from all persons and must not be co-located or operating in conjunction with any other antenna or
transmitter. End-users and installers must be provided with antenna installation instructions and transmitter operating conditions for satisfying RF exposure
compliance.
IC Statement
1. This device contains licence-exempt transmitter(s)/receiver(s) that comply with Innovation, Science and Economic Development Canada’s licence-exempt
RSS(s).
(1) this device may not cause interference, and
(2) this device must accept any interference, including interference that may cause undesired
operation of the device.
2. Changes or modications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.
LEGAL & COMPLIANCE