VIZMONET BreadCrumb Wireless Nodes (ES1-2450R) : User's Guide : Page 21

Please note that Rajant warranty protection does not cover any damage caused by misuse of power

supplies or by use of third-party power supplies.

Warning

In order to avoid sparking and possible damage to the unit, connect the powered Ethernet Output ca-

ble to the BreadCrumb before applying power to the power supply.

Warning

To protect the user and the equipment against the risk of electric shock during high voltage transient

events which may occur when this equipment or its antennas are installed outdoors, protective earth

grounding of the POE power supply is required. Case ground connections are provided on all Rajant

supplied POE power supplies. The case ground connections must be used and must be connected to a

protective earth ground. Protective earth grounding operations must be performed by trained person-

nel, and according to local electrical codes and industry best practices, as well as Rajant’s own recom-

mendations.

For more information on physical installation, grounding, waterproofing connections, see Installation

Guidelines and the Appendix Technical Bulletins.

2.4.3 Ethernet Connector

The Ethernet port on the BreadCrumb ES1 enclosure is the female part of a Genesis Technology sealed

Ethernet connector. In a protected enviroment such as indoors or inside a 3rd party enclosure, a stand-

ard RJ45 male shielded cable may be connected to this port. Elsewhere, the correct sealed mating con-

nector must be used. The mating (male) part is Genesis Technology WAPV-100-AKY0T.

Figure: WAPV-1X00-AKY0T Sealed Ethernet Connector

Instructions for assembling the male sealed RJ45 connector on an unterminated shielded CAT5e or CAT6

Ethernet cable are found in the following Appendix:

Sealed RJ45 Assembly.

Note: Premade Ethernet Cables

Ethernet cables prebuilt with this connector may be purchased from Rajant (P/N: 06-1000068-030, ES1

cable, Ethernet, Cat5e shielded, Outdoor gland, 30ft).

2.5 M8 Connector

The BreadCrumb ES1 includes a 5-pin female M8 connector which provides pins to support one USB 2.0

interface and a physical Reset button (e.g. an LED Configuration / Zeroize Keys and Restore Factory De-

faults Switch).

The ES1 M8 connector is normally covered by a screw-in plastic protective cap. To remove the plastic M8

protective cap, unscrew it counter-clockwise. To re-install the M8 protective cap, screw it in clockwise.

Note