VIZMONET BreadCrumb Wireless Nodes (ES1-2450R) : User's Guide : Page 60

Appendix F: Mounting Instructions

The BreadCrumb ES1 has two mounting holes which are found on the center left and right of the front

and back of the ES1. The mounting holes are 131 mm (5.15 inches) apart (center to center) and are in-

tended for M4 machine screws with washers to distribute the pressure on the plastic.

The two mounting holes are accessed from the front of the BreadCrumb ES1 via small flip-up access com-

partments on the left and right front border of the ES1.

Figure: BreadCrumb ES1 Front Flip-Up Mounting Hole Accesses

1. Front flip-up mounting hole accesses

Tip Regarding Orientation

The following simplified diagrams do not show the external features of the BreadCrumb ES1 such as the

antenna ports, Ethernet port, Status LED. In all vertically-oriented diagrams, the side with the Ethernet

port, M8 port, Status LED is facing down. The flip-up covers on the front of the mounting hole accesses

are also not shown in the following diagrams.

The two mounting holes are located on the back of the BreadCrumb ES1 as shown below.

Figure: BreadCrumb ES1 Back Mounting Holes

1. Mounting holes from back of ES1

A pole mounting bracket and a 35mm DIN rail mounting bracket are available for the BreadCrumb ES1.

F.1 Pole Mounting Bracket

The pole mounting bracket for BreadCrumb ES1 attaches to the back of the ES1 as described below. The

ES1 pole mount bracket is Rajant P/N 12-100115-001.

The following diagram shows a BreadCrumb ES1 with pole mounting bracket attached. Note that the

bracket has a choice of two pairs of slots where a hose clamp can be threaded. A hose clamp for a narrow

diameter pole should be threaded only through the inner pair of slots (thread the hose clamp down into