Installation Instructions User Manual

CiG-Blue Bluetooth Hands-free

Installation Guide

NOTE: The instructions contained within this installation guide are general guidelines for the installation of the CiG-Blue

hands-free kit into an automobile. Due to the variety of vehicles on the road today, this document does not take into

consideration the individual technical requirements for each and every vehicle. Consult the vehicle manufacturer for detailed

vehicle-specific information.

Before beginning the installation, consider the placement of the CiG-Blue system components and the necessary cable routing

paths- verify that the cables for the microphone and CiG-Blue button will reach the desired locations. Ensure that the

components do not interfere with the operation of the vehicle or it’s safety systems.

Vizualogic CiG-Blue Bluetooth Hands-free System Overview:

1. CiG-Blue Button: Designed to replace the vehicle’s 12V power outlet / cigarette lighter receptacle. The CiG-Blue

button comes packaged with black and silver trim rings- each in three different sizes. The variety of colors and sizes

allows the CiG-Blue button to mount unobtrusively in most vehicles. If use of the power outlet / cigarette lighter

receptacle needs to be retained the CIG Blue button can be installed anywhere a 15/16ths (24mm) hole can be made.

2. Intermediate button harness connector

3. CiG-Blue Button to Control Module connector

4. Control Module: Installs underneath the center console, or behind a trim panel out of view. Avoid installing the

control module inside a closed metal housing or in a location where it would be shielded from stereo waves as this

may impair the Bluetooth functionality. Can be mounted with the supplied Velcro pad or wire ties.

5. System Harness to Control Module connector

6. Microphone input connector

99-75001-000

PAGE 1
CiG-Blue Bluetooth Hands-free Installation Guide NOTE: The instructions contained within this installation guide are general guidelines for the installation of the CiG-Blue hands-free kit into an automobile. Due to the variety of vehicles on the road today, this document does not take into consideration the individual technical requirements for each and every vehicle. Consult the vehicle manufacturer for detailed vehicle-specific information.
PAGE 2
7. 8. 9. 10. 11. 12. 13. 14. 15. 16. Intermediate microphone harness connector Microphone: Typically installed at the top of the driver’s side A-pillar, top of the steering column, or on the overhead console. Can be mounted using the microphone’s magnetic base or supplied with the adhesive pads. System Harness ‘12V BATTERY’ (yellow, fused): 12v constant power input. ‘ACC IN’ (red, fused): 12v accessory power input. ‘ACC OUT’ (Blue): 12v accessory power output. ‘EART’ (black): 12v ground.