User Manual

A: 111 refers to Normal display mode, content will be shown on the screen in normal condition.
B: 222 refer to Reflecting display mode, content will be shown on the screen in opposite side in order to be reflected on
the windscreen correctly.
C: 333 refer to Upside-down display mode, content will be shown on the screen upside-down in order to fit the specific
position in the car, such as behind the front rearview mirror. (for certain vehicle models only)
2.
Set the speedometer unit (KM or Mile)
A: Long press the Enter button, if you see number 100 shown on the screen, which means KM/h
B: Long press the Enter button, if you see number 161 shown on the screen, which means MPH
C: The default speed meter unit is set as KM/h
3. Set the over-speed alarm rate
A: Press the Up Button or Down Button to increase or decrease the speed rate
B: The default alarm speed rate is 120KM/h
C: A three times “Beep” sound alarm will be triggered when over speed occurs.
D: No more alarm will be triggered when over-speed is detected continuously.
4.
Fatigue Driving Alarm
In every hour, system will trigger a fatigue driving alarm with continuous driving time displayed, in order to remind driver to
avoid drowsy-driving.
Example: 001 means one-hour continuous driving, 002 means two-hour continuous driving and so on.
5.
Adjustable Speed Slightly
The display speed could be adjusted by hand. Press and hold the up button and Enter button at the same time. It will
show the numbers from 650 to 669.
Default speed rate is 665, if you want to increase the display speed with 1KM/H, adjust rate to 666; And if you want to
decrease it with 1KM/H, adjust rate to 664.
Note:
A: System will start calculating total driving time and mileage when device is powered on.
B: Parking time is not included in the calculations in order to increase the data accuracy.
C: Mileage less than 1KM will be considered as invalid data
D: Once the vehicle stops for a few seconds, you will see data displayed on the screen in order as total mileage, and then
the total driving time in minutes.
E: All driving data will be cleared once the vehicle is engine off, and system will start the calculation again when the car
power resumed.
6. How to paste reflecting sticker
1. Clear the car windshield;
2. Tear the reflecting sticker and paste it on the car windshield;
3. Gently squeezed out the air bubbles;
4. It can be used repeatedly.
7. Technical Specifications
1. GPS positioning time: 1 to 5 minutes in the open air (The bad weather will affect the positioning time).
There is no GPS signals indoors.
2. Speed deviation: Since the speed data comes from the GPS satellite, slight deviation is unavoidable.
3. Input voltage: DC 5V Input current: DC 50-120mA Power bank for power supply is supported.