Specifications

Eccellenza Café – Operating Manual
70 May 13, 2015
Rinse Cycles
Brewer Rinse Cycle
1. Add VKI approved brewer cleaner to the brew chamber.
2. Press the "R
INSE CYCLE" button on the control panel inside the front door.
To exit the rinse cycle if it was pressed accidentally, press the “PREVIOUS”
button on the front display.
3. Select the type of rinse cycle required. For a brewer rinse, press the "Coffee
Rinse" button on the front selection panel to begin the cycle.
To cancel the rinse cycle if it was pressed accidentally, switch OFF the
machine using the main power switch at the rear.
a) The piston will move to the top of the cylinder, water will pour in, and
the brewer will pause for about 5 minutes. During this time, the cleaner
breaks down all the oils and stains that have accumulated in the brewer.
b) After the 5 minutes have elapsed, the brewer will cycle, dumping the
cleaner into the waste container in the process. The brewer will then
automatically cycle water seven consecutive times to rinse the cleaner
from the brewer. After the rinse cycle is completed, the brewer will
stop and the coffee maker will automatically exit the rinse mode.
c) After the rinse cycle is complete, brew a few cups of coffee to re-
lubricate the brewer.
WARNING: Make sure the waste container is under the
brewer spout to catch the water coming from the brewer
(throughout the complete rinse cycle).