User`s manual

HEADSPEAKER – 5.1 HEADPHONE SYSTEM
5 Microphone for voice
• Only operates during USB connection
• Can be used, for example, in online-gaming
2.2 Re ar Pa nel C onnectors
• LINE IN: Stereo (stereo encoded surround) line input, 3.5mm jack
• USB: digital multichannel audio input / set-up using a computer
• SENSOR: head tracking sensor connector, 3.5mm jack
• HEADPHONES: headphone output connector (binaural 5.1-audio), 3.5mm jack
2.3 C onne ctin g for U S B-audio and S et-up
• Attach the head tracking sensors (part #2) to your headphones using the provided strip
or other suitable way. Make sure that connection is secure and sensors are firmly in
place (see figure 5). Please note that orientation is significant, sensors must face
towards the DSP unit and have a clear line-of-sight.
• Attach signal cable (part #5) between head tracking sensor's connector and DSP-unit's
”sensor” connector.
• Attach headphone's signal cable to DSP-unit's “headphones” connector (figure 6).
• Attach USB-cable (part #3) between a computer and the DSP-unit.
• Insert installation media into computer's drive and proceed with software installation
(see chapter 3. for further information).
• Perform the set-up procedure using the diagnostic application as described in chapter 4.
Page 6
Figure 4: rear panel connectors of the DSP unit