User guide

52
M5000 Series: User Guide
Issued June 20, 2007
Mezzanine PMC Carrier
6.3 Installing PMC Modules onto the PMC Carrier
The M5000 is shipped with two PMC filler panels mounted in the front panel. They act as EMC
shielding in unused PMC positions. Before installing a PMC module, the filler panel(s) must be
removed. This is done by pushing them out from the backside of the front panel
Step 1: Remove the Mezzanine PMC Carrier board from the M52xx.
1. Remove the four screws that attach the PMC Carrier board to the M52xx board. These screws
are removed from the rear of the M52xx board. See
Figure 6-3
2. Carefully remove the PMC Carrier board from the M52xx.
Warning! Be extremely careful when inserting screws to secure PMC modules.
Touching component leads, or the printed circuit board itself, with a screwdriver may
cause permanent damage to the board