User's Manual
Table Of Contents
- Introduction and Features
- Getting Started
- Presets
- Video Controls
- Fullscreen
- Transitions
- Production Clocks
- Categories
- Fade Bar
- Pause Inputs
- Overlays
- Right Click Menus
- Settings
- Inputs
- Input Settings
- Audio
- Recording
- Live Streaming
- External Output
- Keyboard, MIDI and Controller Shortcuts
- Activators - MIDI Lights and Faders
- vMix Control Surface
- Web Controller
- Instant Replay
- PTZ - Pan Tilt Zoom
- NDI - Network Device Interface
- SRT - Secure Reliable Transport
- Data Sources
- vMix Call
- GT Title Designer
- vMix Title Designer (Legacy)
- PlayList
- MultiCorder
- Tally Lights
- Interlaced Support
- Statistics
- Snapshot
- Padlock
- Scripting and Automation
- Developer Information
- Shortcut Function Reference
- Safe Areas
- Undo Button
- Waveform and Vectorscope Monitor
vMix User Guide
171 / 208
MultiCorder is an advanced feature found in the 4K and Pro editions of vMix.
It provides the ability to record the raw video and audio from capture inputs to separate files in addition to the
main vMix Recording.
Note: Instant Replay and MultiCorder cannot be used at the same time.
MultiCorder has the following minimum system requirements:
·
Solid State Disk (SSD) for storing recordings.
·
Intel Core i7 Quad Core processor or higher
·
High end graphics card with at least 1GB of on board memory
The number of simultaneous recordings and the type of recording formats will depend
on the processing capabilities of the computer.
The interface above appears by clicking the Cog Button next to MultiCorder in the main interface.
All available Camera and NDI inputs are listed within the MultiCorder window along with the four Output
channels. Tick the source you wish to record and click Start.
SRT inputs can also be recorded, however please note that SRT will always be recorded in its native
Transport Stream (.ts) format and any recording settings except the recording folder will be ignored.
NOTE: Any source with irregular timing such as NDI-HX, Desktop Capture and vMix Call are not
supported by MultiCorder and should not be used.