User's Manual
Table Of Contents
- Introduction and Features
- Getting Started
- Presets
- Video Controls
- Fullscreen
- Transitions
- Production Clocks
- Categories
- Fade Bar
- Pause Inputs
- Overlays
- Right Click Menus
- Settings
- Inputs
- Input Settings
- Audio
- Recording
- Live Streaming
- External Output
- Keyboard, MIDI and Controller Shortcuts
- Activators - MIDI Lights and Faders
- vMix Control Surface
- Web Controller
- Instant Replay
- PTZ - Pan Tilt Zoom
- NDI - Network Device Interface
- SRT - Secure Reliable Transport
- Data Sources
- vMix Call
- GT Title Designer
- vMix Title Designer (Legacy)
- PlayList
- MultiCorder
- Tally Lights
- Interlaced Support
- Statistics
- Snapshot
- Padlock
- Scripting and Automation
- Developer Information
- Shortcut Function Reference
- Safe Areas
- Undo Button
- Waveform and Vectorscope Monitor
vMix User Guide
172 / 208
The following options are also available:
Recording Format
vMix AVI, AVI, MKV, MP4 and FFMPEG are available as recording options in MultiCorder.
For more information about these formats see Recording Setup.
Fault Tolerant Recordings
It is recommended that a fault tolerant recording format is selected when using MultiCorder.
This means in the event of a power outage, the recording will still be recoverable.
See Fault Tolerant Recordings for a list of options available.
Folder
Select the folder to place the video files. This will need to be a fast storage device as listed above under the
system requirements.
The more cameras that are recorded simultaneously, the greater chance of dropped frames if the storage
device is unable to keep up.
Audio
Select and audio source to include with each recording. This can either be Input which includes the
embedded audio in the source, or Master to record the main audio mix.
Note: If recording one of the Output channels (Output 1-4) the audio recorded will always match the audio
bus selected in Settings - Outputs / NDI for that particular output.
New File Every
Split the recording into a new file every x Minutes.
Record NDI in original MOV format
When recording NDI sources, you can select to record in the same compression format as NDI itself (MOV)
by checking this tickbox.
This allows recording NDI sources without any additional system load or CPU usage as the video does not
need to be re-compressed.
When recording NDI in this mode, all MultiCorder settings except the recording folder are ignored, including
audio source and "new file every".
Change Recording Folder
Each source can be saved into its own folder or storage by highlighting the item in the list and selecting
Change Recording Folder.
To change the folder of two or more sources, highlight them in the list before selecting Change Recording
Folder.
To change all sources to the same folder again, deselect all items then select Change Recording Folder.
WAV File Record
See WAV File Record
Tally Lights
vMix supports a number of Tally Lights options