Specifications

51
EATON Pulsar Series and Powerware Series Product Catalogue
Eaton BladeUPS
TECHNICAL SPECIFICATIONS
General
Power Rating 12 kW per UPS module
Efficiency Up to 97 per cent
Heat Dissipation 371W/1266 BTU/hr at 100% rated load
Cooling
Fan cooled, temperature microprocessor
monitored; front air entry, rear exhaust
Audible Noise,
Normal Operation
<60 dBA at 1 meter
Altitude Before
Derating
1000 meters (3300 ft ASL)
Input
Input Voltage 400 Vac
Voltage Range 400V: 311 to 519 Vac, phase to phase
Frequency Range 50 or 60 Hz, ±5 Hz
Input Current
Distortion
<5% with IT loads (PFC power supplies)
Input Power Factor >0.99 with IT loads (PFC power supplies)
Inrush Current Load dependent
Input Requirements Three-phase, four-wire + ground
Bypass Source Same as input (single feed)
Generator
Compatibility
Fast sync slew rate for generator synchronisation
Output
Rated Output Voltage 400V: 180 to 240 Vac, Ph to N
Output
Configuration
Three-phase, four-wire + ground
Output Frequency
(nominal)
50 or 60 Hz auto-detection on startup
Frequency
Regulation
0.1 Hz free running
Load Power
Factor Range
Lagging: 0.7
Leading: 0.9
Total Output
Voltage Distortion
<3% with IT loads (PFC power supplies)
<5% non-linear or non-PFC power supplies
Battery
Battery Type VRLA - AGM
Battery Runtime
(Internal)
13 minutes at 50 per cent load
4.7 minutes at 100 per cent load
Battery String
Voltage
240 Vdc
Battery Test
Automatic battery test standard
(remote scheduling capable)
Manual battery test from front display
Battery Recharge
Profile
ABM three-stage charging technology
Battery Cut-off
Voltage
Variable from 1.67 VPC at <5 min. runtime
Battery Low
Condition
Announced with alarm
Extended Battery
Capability
Yes, add up to four additional 3U battery enclosures
(~34 min at 100 per cent load, >1 hour at 50 per cent
load)
Physical
Dimensions (HxWxD)
UPS
261 (6U) x 442 x 660 mm
132 (3U) x 437 x 660 mm
Note:
Total Chassis Weight
without batteries or
electronics
Total Chassis Weight
with batteries or
electronics
46 kg
140 kg
Total UPS Weight
without Batteries
61 kg
Total UPS Weight
with Batteries
140 kg
EBM Weight 77 kg
Communications and User Interface
Software
Compatibility
X-Slot Bays
UPS ships with Software Suite CD containing
LanSafe power management software and a trial
version of PowerVision
Two available for the cards listed below
Control Panel LCD
Two lines by 20 characters
Four menu-driven interface buttons
Four status at a glance LEDs
Multi-language English standard; 20 languages available
Configuration
Changes
User capable, firmware auto configures
Dry Contact Inputs Two, user-configurable
Dry Contact Outputs One, user-configurable
Service
Installation User capable, located in the IT racks
Preventative
Maintenance
User capable, optional factory service available
Corrective
Maintenance
User capable, optional factory service available
Serviceability
Features
Hot-swappable batteries
Hot-swappable electronics module
Automated internal maintenance bypass
Auto-configure firmware
Flash firmware upgradeable
Certifications
EMI IEC 62040
Surge Protection ANSI C62.41, Cat B-3
Hazardous
Materials (RoHS)
EU Directive 2002/95/EC Category 3 (4 of 5)
Warranty
Standard 12 months
Warranty Repair Factory depot repair or replace
Options and Accessories
Detachable input cord
Detachable input/output cord assembly
Detachable paralleling cord assembly
Extended Battery Modules (EBMs)
3U output sub-distribution module
0U to 3U rack power strips
60 kW Powerware BladeUPS Parallel Bar
Four-post rail kit
Optional X-Slot Communication Cards
Application Card
Web SNMP ConnectUPS-X Web/SNMP Card
Environment Monitoring
EMP Environmental Monitoring Probe
(requires Web/SNMP card)
Modbus® RTU Modbus Card
IBM eServer™
(i5™, iSeries™,
or AS/400), industrial
Relay Interface Card
Parallel Powerware Hot Sync Card
Remote Monitoring Modem Card
Remote LCD Display ViewUPS-X
Recommended ePDU:
Y032440CD100000
RPM - Rack Power Module (BladeUPS in, 12xC13 +
6xC19 out) 20 ft lead
PW107BA0UC08
ePDU - Basic (0U, Dual 16A C20 in, 24xC13+ 8xC19 out)
use in addition to RPM
PW107MI0UC08
ePDU - IP Monitored (0U, Dual 16A C20 in, 24xC13+
8xC19 out) use in addition to RPM