Specifications

EMC CIS Series 1 Pod Installation and Configuration Guide
1/26/2015 Copyright © Network Development Group, Inc. www.netdevgroup.com Page 16 of 23
4.6 Create the Master EMC CIS Series 01 Pod
This section will assist you in adding the EMC CIS Series 1 Pod to your NETLAB+ system.
1. Login into NETLAB+ with the administrator account.
2. Select the Equipment Pods link.
3. Create a new pod by scrolling to the bottom and clicking the Add a Pod button.
4. On the New Pod Wizard, page click Next.
5. Then select the EMC CIS Series 1 pod radio button and click Next.
6. Select a Pod ID and click Next.
It is best practice to use a block of sequential ID numbers for the number of pods you
are going to install. The Pod ID number determines the order in which the pods will
appear in the scheduler.
7. Type in EMC_CIS_Series01_Master for the Pod Name and click Next.
8. To finalize the wizard, click OK.
For additional information, please refer to the NETLAB+ Administrator Guide.