System information

44 Dialogic
®
HMP Software Release 3.0WIN Release Guide — December 2010
Dialogic Corporation
Installation and Configuration
past. When you install the Dialogic
®
HMP Software Release 3.0WIN, a shortcut to the
web site containing the user documentation will be placed on the Start menu as follows:
Start > Programs > Dialogic HMP > Documentation > User Documentation.
User documentation that was installed with a previous release will be removed.
For complete installation information, see the Dialogic
®
Host Media Processing Software
Release 3.0WIN Software Installation Guide.
4.2 Configuration
This section describes the configuration software capabilities that are supported in the
Dialogic
®
Host Media Processing Software Release 3.0WIN. Configuration is performed
after the system software is installed, using the Dialogic
®
Configuration Manager (DCM)
utility. The Dialogic
®
DCM utility allows you to configure:
• Dialogic
®
HMP Software
• Bridge Devices
• Dialogic
®
Digital Network Interface boards
• TDM bus
In addition, you may modify FCD file parameters associated with a Dialogic
®
Digital
Network Interface board by editing the board’s .config file.
For detailed configuration information, see the DCM Online Help and the Dialogic
®
Host
Media Processing Software Configuration Guide.
Trunk Configuration
The trunks on a Dialogic
®
Digital Network Interface board can be configured for both the
media load and, on a trunk-by-trunk basis, either a T1 or E1 protocol. Trunk configuration
can be accomplished either through the Dialogic
®
Configuration Manager (DCM) utility
using the Trunk Configuration Property sheet or programmatically using the Dialogic
®
NCM API function NCM_ApplyTrunkConfiguration( ).
For information about configuring the trunks using DCM, see the DCM Online Help. For
information about configuring the trunks programmatically, refer to the Dialogic
®
Native
Configuration Manager API Library Reference and the Dialogic
®
Native Configuration
Manager API Programming Guide.