Owner`s manual

28
OWNER’S MANUAL
AV quattro /
9.5 HOW TO CONFIGURE AV bit IN
Before starting the configuration of the amplifier or amplifiers equipped with an AV bit IN digital input module, set and
finalize the processor (bit Ten D / bit One) that will interface with the system.
The processor channels specialized in “Digital output / AC Link - AD Link” will interface with the amplifiers equipped
with the AV bit IN input module, as shown in the following procedure.
In the “CHANNEL MAP” of the bit Ten D PC software, the specialized channel with digital output are highlighted in
green, while for the bit One it should be written down which output channels are assigned the digital format (AD Link
- AC Link) during the “I/O Configuration Wizard”.
Set the processor overall volume at a level of -45 dB, which does not endanger the system speakers
during installation / adjustment.
Before starting to configure the AV bit IN module and after setting the processor (bit Ten D / bit One), turn the sound
system off and then on again using the DRC SRC knob.
T P
aMS ST
MO
ST
MO
MS
A78
aA
A 8
C 8
MENU ENTER
ENTER
MENU
UP or DOWN
UP or DOWN
ENTER
MENU
ENTER
MENU
UP or DOWN
UP or DOWN
ENTER
MENU
UP or DOWN
UP or DOWN
ENTER
MENU
ENTER
MENU
END
MENU
START
a =A Channel
a
=A Channel
=B Channel
=B Channel
m s = Mono/Stereo
m s = Mono/Stereo
c =C Channel
=rmware
UP or DOWN
UP or DOWN
UP or DOWN
UP or DOWN
UP or DOWN
UP or DOWN
UP or DOWN
A Channels Mode:
Stereo
A Channels Mode:
Mono
B Channels Mode:
Stereo
B Channels Mode:
Mono
MENU D OWN UP ENTER
***
MENU DOWN UP ENTER
a = Adress
a = Adress
a = Adress
2
4
5
ST:
MO:
ST:
MO:
C 8 :
Set Amplier Type
To set AV bit IN for
AV uno amplier
To set AV bit IN for
AV due amplier
To set AV bit IN for
AV quattro amplier
To set AV bit IN for
AV 5.1k amplier
a78:
a8:
A Ch stereo mode address 1/2
A Ch stereo mode address 7/8
A Ch mono mode address 1
A Ch mono mode address 8
B Ch stereo mode address 1/2
B Ch stereo mode address 7/8
B Ch mono mode address 1
B Ch mono mode address 8
C Ch mono mode address 1
C Ch mono mode address 8
A Ch stereo
A Ch mono
B Ch stereo
B Ch mono
Set A Channels Mode
Set B Channels Mode
(AV quattro - AV 5.1k)
Set ADLink Signal for the amplier
A channels,
see the digital channels
outputs on the
“CHANNEL MAP” of the
Audison processor
(bit Ten D / bit One)
PC software.
Set ADLink Signal for the amplier
B channels (AV quattro - AV 5.1k)
of amplier, see the digital
channels outputs on the
“CHANNEL MAP” of the
Audison processor
(bit Ten D / bit One)
PC software.
Set ADLink Signal for the amplier
C channels (AV 5.1k) of amplier,
see the digital channels
outputs on the
“CHANNEL MAP” of the
Audison processor
(bit Ten D / bit One)
PC software.
View Firmware Version
5:
4:
2:
Esample: Information displayed on the AV bit IN
which is dedicated to the AV quattro amplifier.
9