User's Manual

Values & Setting
Location
DescriptionSupported
Devices
Parameter
Users may prefer to disable
headsets when using other
Bluetooth peripherals.
1 to 10 seconds
(default is 6)
Specifies how long (in seconds)
an operator is required to hold
Psion,
Intermec
SrxHighPowerPairingDelaySeconds
the plus and minus buttons on
Value can be 0 when
AutoPair is enabled for
headsets.
an SRX headset while in low
power pairing mode before
entering high power pairing
Set in VoiceConsole > Device
Profile
mode. Not used for SRX2
headsets.
0 = disabled (default for
Vocollect Voice versions
prior to VoiceCatalyst 1.2)
1 = enabled (default for
VoiceCatalyst 1.2 and
newer)
Enables a device to remember
the last automatically paired
headset after it has powered
down. Upon powering up, the
device attempts to connect to
that headset instead of going
into pairing mode.
A500,
T5-Series,
Psion,
Intermec
SrxPersistAutomaticPairing
Set in VoiceConsole > Device
Profile
Note: When the device is
placed into a charger, the
pairing will still clear as
in normal functionality.
This parameter is ignored
if the SrxAutoPairEnable
configurable parameter is
disabled.
0 = disabled (default)
1 = play mixing of TTS and
mic data
Enables/Disables the ability
to listen in on both sides of the
SRX Wireless Headset
A500,
T5-Series
SrxSupervisorAudioEnable
conversation through the use
2 = play the TTS audio only
of a remote listening kit or
Set in VoiceConsole > Device
Profile
wired headset plugged into the
device.
Note: Due to increased
bandwidth required by
Supervisor Audio mode,
headset audio
performance may sound
degraded while
Supervisor Audio is
enabled. For optimal
performance, be sure the
parameter is set to "0"
(disabled) during all
regular SRX wireless
headset use.
Confidential: For informational use by Vocollect Resellers and customers only
Vocollect Wireless Headsets | 147